scale modeling database | stash manager
alfisti
Daniel Mysak (alfisti)
AT

...in progress

Album image #1
Album image #2
More than enought details for what will be visible at the end. 
 

Album image #3
Only added some seat belts made from Tamiya tape to the seats, no more details needed inside the fuselage. 
 

Album image #4
The cabin windows needs some attention but at the end they fitted well. 
 

Album image #5
I put some weight inside the nose, not sure if it´s neccesary but better than a tail sitter. 
 

Album image #6
The fuselage halfes needs slight effort to get together. 
 

Album image #7
Finished the fuselage, all fitts without any puty. 
 

Album image #8
Same good fitting on the wings, only some sanding is required. 
 

Album image #9
Album image #10
Opend some air in- and outlets. 
 

Album image #11
Opend some air in- and outlets. 
 

Album image #12
The intake section of the engines was cut. 
 

Album image #13
Album image #14
Good fit on the cockpit clear parts. 
 

Album image #15
Album image #16
Underside of wing and fuselage transition looks okay with a little sanding. 
 

Album image #17
On the upper side putty was used to close two gaps. 
 

Album image #18
Album image #19
Album image #20
Position lights were cut off and built new from clear sprue. 
 

Album image #21
Position lights were cut off and built new from clear sprue. 
 

Album image #22
Album image #23
Album image #24
Scratch built antenna from some etched parts frame. 
 

Album image #25
The wing fences was sanded down as the were much to thick. 
 

Album image #26
Some more antennas were added. 
 

Album image #27
Album image #28
Added scratch build wipers, the kit parts are too poor detailed 
 

Album image #29
Album image #30
Album image #31
A thin layer of Tamiya Fine Primer shows the last ares which needs more attention. 
 

Album image #32
Album image #33
The demarcation lines for the "Oceanic-Camo" were painted with some pics a reference. 
 

Album image #34
First color was Mr.Hobby C375 
 

Album image #35
Scratch build of the Self-Defence-Pods wich 027 and 028 are wearing. 
 

Album image #36
Album image #37
Album image #38
Album image #39
The 027 and 028 are equiped with a radar warn receiver, which the kit didn´t show. 
 

Album image #40
So I cut off the little cone on the fine and added a piece of sprue. 
 

Album image #41
Next step was the housing of the RWR. 
 

Album image #42
After masking the dark blue with UHU Patafix... 
 

Album image #43
...I sprayed a layer of MR.Hobby C374. 
 

Album image #44
Unfortunately it´s way to bright for the U-125A. 
 

Album image #45
I fixed the problem with a layer of tamiya x-23 clear blue. 
 

Album image #46
Album image #47
Removed the masks and painted some details. 
 

Album image #48
It´s allready finished, last steps were some antennas and the landing gear. 
 

Album image #49
Two RBF-tags were also added to the FOD-covers. 
 

Album image #50
Here you can see the wipers, look much better than the kit parts. 
 

Comments

1 25 November 2018, 18:14
Oleg Bogolei
nice! follow! and wip photos with coments if it is possible)
25 November 2018, 18:57
Daniel Mysak
Welcome, the next pics will be with coments, not much to say about the first one 😉
25 November 2018, 20:10
Cuajete
Interesting. Following.
25 November 2018, 20:58
Łukasz Gliński
Me 2.
25 November 2018, 21:29
Dietmar Kollmann
I take a seat. Ha,ha !
26 November 2018, 12:14
Gordon Sørensen
Following!
26 November 2018, 14:24
Daniel Mysak
The interior is finished, don´t payed to much attention to details which are not visible at the end. Started glueing the fuselage halfes together, needs some effort but could been worse.
27 November 2018, 18:22
Harry Eder
I´m in too! Nice start 👍
3 December 2018, 09:44
Daniel Mysak
Got some progress with the U-125. The fuselage and the wings are joined, they needed some more attention then the fuselage halves.
17 December 2018, 17:10
Ekki
Watching.
17 December 2018, 17:45
Łukasz Gliński
Great progress
17 December 2018, 19:30
Bryn Crandell
Looking good so far. Watching this one!
17 December 2018, 19:57
Spanjaard
looking interesting!
17 December 2018, 20:26
Thomas CONAN
Cool kit.😉
17 December 2018, 20:36
Daniel Mysak
Thanks guys 👍
18 December 2018, 11:55
Daniel Mysak
Today i sprayed the first color of th "Oceanic-Camo", Mr.Hobby C375.
26 December 2018, 15:28
Daniel Klink
Watching!
26 December 2018, 15:36
ice
I'm in too! A great amount of details in a small scale! 🙂
26 December 2018, 16:16
Nathan Dempsey
I used to have one of these, but I traded it. Nice to see one being completed. I'll be watching for sure.
26 December 2018, 18:29
Harry Eder
Nice progress Daniel! 👍
26 December 2018, 19:18
Cuajete
Fantastic work so far.
27 December 2018, 12:36
Daniel Mysak
Thank you guys, it´s nice to know there are some people watching 😉
27 December 2018, 15:04
Felipe Belalcazar
very nice, i love the hawker jet - too bad you dont see them around more often.
27 December 2018, 15:10
Graham Holmes
Daniel, nice work, love the added detail.

A question, do you think that it would be feasible to remove the belly radar and convert the kit to a regular Biz-jet version? I see this is as the only difficult bit, as the windows are no issue.
2 January 2019, 15:11
Łukasz Gliński
That's a good question Graham, I also wonder whether Sword is going to issue any other versions...
2 January 2019, 17:08
Daniel Mysak
@Graham @Lukaz I would be possible, but there will be a big gap to fill. A bit of work would then be necessary to get the right shape of this section. Maybe Sword brings a new fuselage, without radar, stiffener plates, correct windows,...
2 January 2019, 17:39
Gordon Sørensen
Lookng at the sprue pics, it seems the rear half of the bottom radar fairing is molded into the bottom of the wing, so would need a new mold for that too... but everything else should be OK!
2 January 2019, 18:45
Graham Holmes
@Lukasz @Daniel @Gordon, thanks for the responses. The pictures are most helpful and it looks like quite a bit of a job, but worth it. My brother in law worked on this version of the 125 for Beechcraft in Wichita and would love to make a model of it for him. He gave me a manufacturers model of the Hawker 1000, so worth the effort to convert this one for him. I love the looks of this plane.
2 January 2019, 20:20
Daniel Mysak
After nearly a month since my last update the paint and decals are done.
13 January 2019, 16:06
Nathan Dempsey
Coming along nicely.
13 January 2019, 23:44
Glenn
Watching!
14 January 2019, 06:58
Łukasz Gliński
Looks awesome in the ocean camo. Btw. Are the decals for '027' supplied in the box?
14 January 2019, 07:28
Daniel Mysak
Thanks guys 👍
@Łukasz Unfortunately there are only decals for one grey and one blue(028) aircraft in the box, no spare to create other regs. I used some numbers from a Hasegawa T-2 Blue Impulse kit which thankfully @Harry Eder gave to me.
14 January 2019, 16:52
Harry Eder
The decals were from the Platz T-2 Daniel 😉
15 January 2019, 06:21
Łukasz Gliński
Thanks for the info guys. Does it mean this ocean camo is a whif?
15 January 2019, 12:47
Daniel Mysak
No whif, 027 and 028 are painted in two different versions of the Oceanic-Camo.
15 January 2019, 17:23
Bernd Korte
Unusual subject and nice camo!
15 January 2019, 18:42
Łukasz Gliński
Thx Daniel, I find it very interesting 🙂
15 January 2019, 20:48
Cuajete
Yes, very interesting 👍
16 January 2019, 13:13
Alberto Michieletto
Very nice
20 January 2019, 20:41
Alexander Grivonev
Nice detail work, great camouflage colors, great build! 👍
21 January 2019, 06:20
Glenn
Looking great, What paint did you use for the two blues? I like to see a civil version released too! Either a Hawker 800 or the 1000 version go well with all the Amodel Biz Jets.
21 January 2019, 13:27
Daniel Mysak
@Glenn In picture No.23 you can see the color set from Mr.Color I used. It´s special for the Japanese Oceanic Camoflage and will fit perfect for a F-2 or Phantom but didn´t match the light blue of the U-125 at all. So I sprayed a layer of Tamiya Clear Blue on it to get a better result.
21 January 2019, 14:38
Spanjaard
excellent.
21 January 2019, 15:44
Daniel Mysak
I reached the finish line last week, the U-125A is done. Last things to do were some antennas, the landing gear, the wipers and the FOD-covers.
13 February 2019, 18:34
Laurent VILLANUEVA "HELLER-forever"
great
13 February 2019, 18:54
Daniel Klink
Impressive result Daniel 👍 Congrats
13 February 2019, 19:01
Stefan Fraundorfer
Congratulations Daniel! A very nice model. I like the camouflage.
13 February 2019, 19:02
Daniel Mysak
Thank you guys. I´m glad I allready finished the jet. I like the result although I am not completely satisfied with the build.
13 February 2019, 19:12
Markus Antonius
it is so refreshing to see this little beauty - a welcome change to all those 109s (even though i like 109s)... 🙂 jasdf always nice to see 🙂
13 February 2019, 19:16
Łukasz Gliński
Very cool build, Daniel, congrats
13 February 2019, 20:20
Calvin Gifford
Lovely! I wish I had taken more photos of Japanese aircraft while I was stationed there!
13 February 2019, 20:42
Nathan Dempsey
Cane out great! Love that camo.
13 February 2019, 21:38
Harry Eder
Great build mate 👍
14 February 2019, 07:15
Cuajete
Very nice. Congrats!
22 February 2019, 13:33
Daniel Mysak
Thanks a lot for all your positive response. 👍
22 February 2019, 15:56
Spanjaard
very well done!
25 February 2019, 22:13

Project info

66 images
1:72
Completed
1:72 Raytheon U-125A (Sword SW 72119)

All albums

View all albums »