home made spraybooth

big box , a rotating plate from Ikea, and a big kitchen fan 

of course, some universal kitchen exhaust filter to protect the fan. and some metal net to keep it together 

drilled back of the box, and set up the fan 

built a frame to hold the filter and the metal net (behind the filter). fit at the end of the box. filter can be easily changed 

added a couple of aluminium rods to hold a simple plastic sheet. the sheet can be replaced when fully covered with paint. I want to keep the booth clean 🙂 

and of course, covered the rotating plate as well. 

made a frame in aluminium around a thick transparent plastic, placed a fitting so the pipe can be added and removed, but have a tight fitting. with a safety pin made of metal rood. frame is hanging from a couple of hooks in the wall and it can be removed after the end of airbrush session. the pipe can be folded and place inside of the box to be taken out of the way. it is kept in place with safety pins in the back of the box and in the frame on top.
in the frame has also a thigh fitting and the pipe is kept in place with another safety pin.
this picture was taken before the final placement of the frame and filter inside.
the whole thing can be kept (closed so no dust will go inside) on top of a cabinet, and installed in about two minutes