Jordan 191 Zanardi

All done but the lite green markings i'm waiting for.

Trimmed front wing, low down force.

Extra brake duct...

All sanded smooth...

Comments

10 22 August 2018, 04:17

bossy122
Kit wing on the right, old, non puttied one on the left. Had to practice masking off that light green line as those kit decals for it S U C K!

22 August 2018, 04:19

bossy122
Progressing...

29 August 2018, 02:29

Peter Hardy
Very nice paint!

29 August 2018, 03:47

bossy122
TS35 and TS44.

29 August 2018, 06:28

bossy122
As far as I can tell, Zanardi ran without the little radiators at the rear wheels so I had to fill in the spaces with some epoxy putty.

29 August 2018, 18:42

bossy122
Some carbon fibre for the floor...

5 September 2018, 18:49

bossy122
Some 1 24 carbon and clear flat over the headrest to give it a material look.

16 September 2018, 18:20

bossy122
Fin

16 October 2018, 21:37

Peter Hardy
Well done Bossy!!

17 October 2018, 00:40

bossy122
Thank you.

17 October 2018, 01:15

Holger Kranich
One of the most beautiful F1 cars ever! Well done, bossy!

17 October 2018, 12:11

bossy122
Thank you.

17 October 2018, 18:07

Kees Kleijwegt
Great job on this Jordan bossy122! 👍

17 October 2018, 19:06

bossy122
Thanks. The one thing I notice; I cheat on the inside tyre markings by only doing one and then positioning it so that one is seen....I forgot to do that last part. Drivers left front is blank.....oops.

17 October 2018, 19:09

Roberto Rocat
Beautiful Zanardi's ride 👍

17 October 2018, 19:38

bossy122
Thanks again.

18 October 2018, 18:08

bossy122
I found some more pics of this on my PC ( instead of my tab). And I didn't bother to note that this project includes a 3D printed set of pieces to correct the front wing and add snorkels to the brake ducts on the rear wheels which are also necessary for anyone wishing to make a correct Michael Schumacher version of this car.

12 October 2020, 03:09

bossy122
The 3D pieces can be found here: shapeways.com/produc..9&li=marketplace

12 October 2020, 03:13