Alexandre Reynaldo Dear Allan Gage, sorry for delay...
There are some points of advice in this kit.
Rear suspension assembly is poor. It is necessary to sanding a lot to get fit it in the chassis.
The final assembly of the body with the rest of the kit is very difficult.
27. April 2019, 21:38
Allan Gage Great my least favorite parts already...oh well i shall proceed with caution. Thanks for the response.
Dennis Well done! What Color did you use dir the Green exactly? I was thinking about Tamiya TS 22 for my build...
26. June, 19:49
Alexandre Reynaldo Hi Dennis. It was the color that I used. But it was decanted, because when I aplied directly from the can to the car, it boiled like a soda. So I aplied with a Aztek airbrush over Tamiya primer.
26. June, 21:32
Dennis Hi Alexandre. Thanks Mate! I Never had any Problems using Tamiya Spraypaint. I allways aply them directly from the spray can over a good coat of primer. Before using them i put the spray can in warm water for a few minutes. This way i get very smooth surfaces...
27. June, 10:23
Alexander G. Again, that green is awesome This kit is in the top 10 on my to do list
27. June, 10:54
Alexandre Reynaldo Hi Dennis. Yes, I know the quality of Tamiya spray paints, but I used an old bottle, so I believe that it promotes the strange effect. I searched the internet and found that it is not uncommon. In the old spray can, the gas can incorporate into the paint, the same process of making a coke ... and the only way to solve it, is to decant the paint into a jar and shake it. Open the jar and let the gas escape. Repeat the process even to remove all gas. Do not this with a coke...