Wall

Neuling
I cannot see any mistakes whatsoever. 👍

Rui S
Beautifully done bird & and Great photos too 👍

Anthony lfk
Thanks John ! I have mixed feelings about this kit. The decals were very flimsy, it shrunk and warped when i applied the Softener. The Propeller also look weirs. But you can get aftermarket parts to enhance it.

John
I understand about the decals. Some bad ones can ruin all your work on an otherwise good kit. The really bad part is that you don't know they're bad until you start applying them and then it's too late. Well, not too late, but definitely a lot of work to remove them then start over.

I have found one hint with decals that are not Cartografs: apply the decal as normal with a gentle decal solution like Mr. Mark Setter, then wait a few hours for them to settle before adding a stronger solution. I had some Hasegawa decals that would do the same thing (wrinkle and not smooth out) if I applied softener too soon, but if I waited overnight before applying softener, they behave much better, though they did require a little more messing with to really settle down in panel lines, etc.

Mr James
Top work indeed 👍 I like the subtle weathering details

George Williams
Best looking plane from WW2.

Jack Aaronfeld
I really like how subtle and desaturated the camo is - what paints did you use?

Anthony lfk
Jack, just plain Tamiya Acrylic paint with Mr Hobby Levelling thinner. Any paint will do i believe, thin it like > 50% thinner and low pressure < 15 psi. a 0.2mm needle helps too.

gorby
Oh, lovely job!

Rui S
Great work & photos 👍