Two polish aerobatic TS-11 Iskras

As the planes should be shown in flight, pilots were needed. Unfortunately no Poles could be found, so I opted for two modern Germans and will polish them. As they would not fit into the trainers ejection seats, some sanding and squeezing in a hot water tub was necessary.
I hope that the positioning of the arms allow a good grip of the control stick. 

As usual everything starts with the cockpit. The Deluxe kit contains two planes and two PE frets per plane that allow you to further detail the planes down to the subatomic level.
Basic assembly and painting of the cockpit tub is done. 

As there is a gap between the pilots instrument panel and the fire wall, I added hoses to the rear of the instruments and guided them through the fire wall. 

I call the detail painting ready. 

Pilots prepared with black primer and white lights. 

Basic painting done. Not quite happy with the hue of the flight suit. But it will have to stay like that. 

Them wings: for my project they pose four "problems":
- the lower part of the wing is too thick and had to be sanded down (which was annoying)
- a strong seamline at the airintake which I filled with glue gue
- a blunt end of the wheel well cover which has to be sanded to match the nicely fashioned trailing edge of the wings
... 

...
- and finally the wheel well doors which are designed to be mounted in open position only. To attatch them in closed position some modifications of the doors themselfs were necessary together with some shims to prevent them to dislocate into the wells and finally the closure of some prevailling gaps with styrene. 

Here my best result out of four. Some gaps are still to be filled. 

The second PE fret encompasses parts for further exterior detailling. Among them details for the wheel wells which I obviously did not need, the airbrakes, which I did not use and finally a replacement for the boundary layer fences which really add nicely to the appearance.  

So far only the bases of the boundary layer fences are added, the fences themselves will follow when the wings are attatched and ready for paint. 

I closed the fuselage. After sanding down the diameter of the front firewall and the disc attatched to the exhaust part I did not encounter any fit issues anymore. I only should have put in the pilots first as it was close to impossible to squeeze it in afterwards 

The halfs came together well and there was little to no gap which needed treatment.  

Minor imperfections could be treated with diluted Mr. Surfacer 500. The dent where the 30mm- gun should have been mounted was filled with sprue gue, as were a few small casting imperfections 

Dry fitting shows a good fit of front window and canopy.  

Now the air intakes look much better. 

One set of wings to go. Then I can finally mount them. 

Finally the wings are on. After the effort to get the air intakes right, I spilled glue over one wing. Flushing it away with water immediately, letting it dry for a couple of days and then sanding prevented disaster and loss of detail.  

Mounting the wing required quite a bit of dryfitting, sanding and scribing.  

Now I think the main hurdles of the build should have been passed. Finishing the cockpits with the pilots is next. 

Cockpits done. Pilots squeezed in, their hands wrapped around the control sticks. One or two details to be fixed that got lost during the vigorous handling to press the pilots into service.