Work in progress
Dryfitting at start
Partintioning the wheel bays up to the top
Engraving the inner hull
Interior engraved
Enhancing a bit the cockpit
Preparing the cargo floor for the custom decal
Preparing the seats
Making custom seats with masking tape 1/3
Making custom seats with masking tape 2/3
Making custom seats with masking tape 3/3
Placing the custom seats
Custom seats in place (no floor yet)
Central module with seats and ladder
Scratching the two 1000gal fuel tanks
Preparing the rear ramp
Building the structure holding the scaning/sensing devices
Building the LIDAR and the Infra-red sensor
All in place as it will be
Trying to do chairs....quite hard
All in place !!! 🙂
Comments
9 August 2018, 12:23
Cuajete
Fantastic scratchbuild interior. Interesting technique to build the custom seats 🙂
Watching!
Fantastic scratchbuild interior. Interesting technique to build the custom seats 🙂
Watching!
9 August 2018, 19:33
Florent Perrier
Thanks guys ! =) Soon pictures of the painted interior and the custom 3D printed characters
Thanks guys ! =) Soon pictures of the painted interior and the custom 3D printed characters
10 August 2018, 07:07
Cuajete
Florent, if possible, I would like to know how you carry out the design and printing process of the figures. Thanks!
Florent, if possible, I would like to know how you carry out the design and printing process of the figures. Thanks!
10 August 2018, 12:22
Florent Perrier
Nah i didnt printed by myself. I just used sketchup to import 3d warehouse models, scaled them down to 1/72, then sent the file to Sculpteo, a french 3d printing service. I needed modern male & female humans in sitting position. Sooo hard top find so 3d print was the only option to get them...!
Nah i didnt printed by myself. I just used sketchup to import 3d warehouse models, scaled them down to 1/72, then sent the file to Sculpteo, a french 3d printing service. I needed modern male & female humans in sitting position. Sooo hard top find so 3d print was the only option to get them...!
10 August 2018, 18:30