Leopard 2A4 Marksman
Some rather thick mudflaps...
...thinned down
Some nasty seams here
Ready to be sanded
Hull assembled
And turret in dryfit
Drawn a new barrel for this one. Now time to check if it can be printed
Wheels mounted. Looks like a link is missing here, but I can't find it anywhere
Other side too
And detachable for painting
Hook attachments turned, were shown upside down in the instructions
Track repaired
Ready for primer
Ready for primer
Menacing
Barrels printed by a friend
Barrels printed by a friend
Barrels printed by a friend
42mm awesomeness. .
And barrels dryfitted
Some rear reflectors
And pm the front, also added the additional mudflaps
Added the missing lifting hook
Camo pattern hull as per reference pictures.. topview is a guess
Comments
15 30 May 2023, 18:09
Peter de BruinFollowing! Looking forward to the printing results. It'll be a pretty thin wire under the barrel.
7 June 2023, 05:53
Bart GoesaertThx for interest. Rear tow hooks are shown mounted upside down in the instructions, these are corrected, also the track has been lengthened and side skirts cleaned
7 June 2023, 22:27
Bart GoesaertPictures of the first print of the barrels has been sent, looks promising
11 June 2023, 17:47
AlexanderLooks quite nice and I like the addition of self-made 3D-printed parts - following.
1 July 2023, 10:39
