Sea Harrier FRS.1, What-if Hellenic Navy
Instrument panel
Ejection seat. Used a bit of tape for the seat belts
Gunpods drilled
Putty.. everywhere. Very difficult fit.. A pain!
My 1st (EVER) attempt to preshade.. looks awful 🙁
Top colour
Masked to receive the many black painted bits and parts around the aircraft
Varnished and decaled. S/N on tail fin and HN mark are on their way.
Comments
20 December 2012, 14:09
Dimitris P.K.Thanx Holger. I just applied the last decals and now I'm gonna spray the varnish, so tomorrow will be ready to receive the "very special treatment" a.k.a.: Heavy weathering!!
20 December 2012, 15:18
Dimitris P.K.There you go.. Finished at last!!!
This would be my 2nd completed model in my carrier!
Will make a Harrier in the future again (new molds look nice🙂 ) and I heard the Greek Army needs one.. hmm lets see..
5 January 2013, 01:11
Dimitris P.K.I had so much trouble with this kit. And the result is not so good. Pictures make it look better 😛
Tyvm though 🙂
5 January 2013, 22:18
Album info
In this project, I'm trying to depict a Sea Harrier FRS.1, If it had been acquired by Greece and was in service with the Helenic Navy! Note, that since the Greek Navy has no aircraft carriers, the Harrier would be using the landing areas of the frigates either Class Meko-200HN or Type "S", both able...
