Thread started by toty7584
Thorsten Clemens
added a new photoalbum.
added a new photoalbum.
All comments (19) » 22 August 2019, 18:45
Treehugger
If the resin part for the wheel whells (rear) is too short for the hole in the fuselage, better make sure you decide on moving the bit of resin further back, or forwards. I have a 1:72 project WIP, and I unfortunately moved the resin forwards, when I should have moved it backwards. There was 1mm of gap, that I filled with strip styrene.
If the resin part for the wheel whells (rear) is too short for the hole in the fuselage, better make sure you decide on moving the bit of resin further back, or forwards. I have a 1:72 project WIP, and I unfortunately moved the resin forwards, when I should have moved it backwards. There was 1mm of gap, that I filled with strip styrene.
3 October 2019, 10:54
Thorsten Clemens
Hi, I've kept the things together roughly, visually looks quite ok, but since I have already made bad experiences with Aires, I will adapt dry several times.
But I'm still on the air intake turn, which is immediately primed from the inside
Hi, I've kept the things together roughly, visually looks quite ok, but since I have already made bad experiences with Aires, I will adapt dry several times.
But I'm still on the air intake turn, which is immediately primed from the inside
3 October 2019, 13:38