Vägg

Bruce Huxtable
Have fun on your new model, but make sure to remove any primer from surfaces that will have glue applied. Looking forward to following this project 👍

Srikanth Kadambi
yes will be sanding them
I have 600, 1000 and 2000 gsm sand papers
Do you suggest/recommend anything else?

Bruce Huxtable
I usually gently scrape the surfaces with a scalpel blade, as it can get into small places. Also very good for removing any thin lines from the mould joint line, but used with a little more pressure. Very fine wet-and-dry paper is indeed very useful too. As always, have a little practice on a piece of sprue, holding the blade almost perpendicular to the surface.

Srikanth Kadambi
thanks for this tip Bruce. Will follow this advice

Srikanth Kadambi
thank you so much will explore this option

David R. Meizoso
Exciting moment indeed! Looking forward to see it come together!

Srikanth Kadambi
Thank you David
Waiting for few tools to arrive before I can start

Pierre Pierre
Srikanth keep us updated with pics

Mark Sherwood
If it is the same mould as yellow/sort of brown 6. It is a cracking little kit. Built as an Aldi special.

Srikanth Kadambi
Internet is indeed turning out to be my friend Mark!
Thanks for pointing out the mistake, I did realise only after you pointed it out. It's a steep learning curve & I am starting this hobby 10-12 years late!
No wife problems here😬 coz I don't have one! followed & subscribed to quite a few YouTube channels as well.
Looking forward to improve incrementally in subsequent builds.

Mark Sherwood
Lucky man 36 years and counting. I returned to the hobby in 2017 in earnest in 2019 and I'm still learning. I only started airbrushing last year, so on a learning curve with I e. Pre shading, post shading 😲😳🤔😱 Again mate, welcome to the hobby and the main thing about this hobby is enjoy what you are building and if you like it, that is all that matters. 👍🥸👍

Rui S
Welcome to scalemates🙂

Srikanth Kadambi
thank you so much look forward to learn and grow my hobby