Avia C-2

So, let's get started! 

as you can see - work in progress 🙂 

front engine "plug" in place and since it wasn't perfect fit, a little bit of tack-it worm around the top and side will serve as a sealant. It will not be visible after fitting the front engine cover but just in case. 

undercarriage side panel part glued in lower wing section and on the right side drilled the hole for the clear part 

after drilling, painting with GSI aluminum, clear part glued in place with PVE glue 

now back to cockpit. rudder pedals replaced with PE parts and glued in place, control stick and other PE parts also glued in place 

biggest fun part - glueing the tiny PE controls to the instrument panel 

I hope they will not get ripped of during the painting... fingers crossed! 

front instrument panel finished (PE glue still drying) 

cockpit painted 

and glued into the fuselage 

front instrument panel needed some adjustement to fit properly 

other half of the fuselage also needed some attention 

test fit - gap behind the front instrument panel is the only issue - better aligement and cleaning before gluing the cockpit would solve this. next time I will know better 🙂 

pilot seats in place 

ready for closing the fuselage 

wings glued with the fuselage together at last 🙂 

undercarriage will need to be painted again after the overall coat of silver paint 

small PE part between the pilot and the instructor seat 

canopy masked and ready 

bits ready for painting 

MPR silver - looking good 

bottom black panel painted and undercarriage space masked and painted 

all bits ready for final assembly 

decalling done - ready for the protective coat of gloss (or semigloss - not sure yet) 

And after quick wash, adding small bits - DONE! 🙂 

Kit is great, highly recommended!