Revell F-16C Block32 (1/72)

Some counterweight added avoiding sit down. 

After spending 3 nights (1 hour each, approx) the intake starts looking good for me... I built in resin gear bay and consumed a lot of putty (Tamiya epoxy and Gunze surfacer).  

Resin wheelbay added.  

Enforcement plates added from Crossdelta sheet. Nice addition for a Block32 airframe.  

Some fighting with the joint lines here and there. 

The DreamModel afterburner is made of PE frets. Simple, as it has only 5pcs. On the other hand very complicated. Next time I either keep plastic parts or replace with resin.  

The feathers are just pushed on to show how it will look like. Plan to fix it only after the paint job is done.