Porsche 993

Starting point 

removed the hood locks, also had to fill in the fillercap. At the end was too afraid to scribe a new one, so the model does not have a filler cap 🙂 

 

i had to reinforce the body so that the resin bonnet cover can be installed correctly. 

 

 

i trimmed the exhaust and used a ferrule as an exhaust tip 

this is how ugly the stock exhaust looked, so i had to think of something 

 

 

 

kit wheels. centers in tamiya dark gray metallic (matte) 

 

 

 

since i installed a different tailcover there was no place for a large intercooler. I trimmed it and installed at the front of the car. sorry purists 🙂 

 

 

I almost have no pics of the interior, but i used a new technique for getting the kevlar backing effect of the seats.  

i printed the rwb stripes and some more stuff here and there.
As you can see here the center bar in the lower inlet is still present. I was hesitant whether i should remove it or not. 

 

panel lines done but not wiped 

and here as you can see the center bar was removed, i added some mesh and painted black. The intercooler can be seen in the later pics 

i also had to paint the reflectors of the headlights black to give it more dark look. 

 

 

 

i also added the lower lip at the later stage of the project to give it a lowered look 

 

 

 

here you can see the mesh and the intercooler