In progress
![Album image #1 Album image #1](/albums/img/9/0/4/1446904-120967-46-720.jpg)
![Album image #2 Album image #2](/albums/img/9/0/5/1446905-120967-99-720.jpg)
![Album image #3 Album image #3](/albums/img/9/0/6/1446906-120967-14-720.jpg)
![Album image #4 Album image #4](/albums/img/9/0/7/1446907-120967-51-720.jpg)
![Album image #5 Album image #5](/albums/img/9/0/8/1446908-120967-87-720.jpg)
![Album image #6 Album image #6](/albums/img/9/0/9/1446909-120967-84-720.jpg)
![Album image #7 Album image #7](/albums/img/9/1/0/1446910-120967-36-720.jpg)
![Album image #8 Album image #8](/albums/img/9/1/1/1446911-120967-43-720.jpg)
![Album image #9 Album image #9](/albums/img/9/1/2/1446912-120967-20-720.jpg)
Comments
21 11 April 2023, 20:51
![](/profiles/img/120967-825-s.jpg)
Hi! It's quite old as a kit. The fit works with very little putty on junctions especially on the wing halves. However, the main carriage bays do not fit properly without reworking and there is a lot of raised panel lines to address. 🙂
19 October 2023, 19:31
![](/profiles/img/124684-254-s.jpg)
Ok thanks, would you recommend it for someone who is newer to modeling?
19 October 2023, 22:43
![](/profiles/img/120967-825-s.jpg)
It does fit quite nicely other then the listed limitations. It will allow you to experiment with a few techniques as seams filling, panel rescribing and small sections tweaking without giving you too much of an headache. This was my first serious attempts after 25 years stop so I was basically new to modelling as well. I would go for it 😉
22 October 2023, 20:15