TIE/gs Ground Support

1
December 15, 2019
Image from the comic strip showing the different looking TIE
2
December 15, 2019
The first step was to add the extra support struts to the wings. I used a 10mm wide tape strip to make sure the distances were always the same and then scraped away the surface detail using a chisel
3
December 15, 2019
The extra struts were added using some leftover Fine Molds TIE wing frame pieces cut to size
4
December 15, 2019
The Revell ball was then dressed up with detail pieces and guns, also from a FM kit
5
December 15, 2019
Finally the back of the ball was sanded off and a resin big engine (provided by JBOT) was glued in place
6
December 15, 2019
The big engine piece is designed for a FM kit but it looks OK on the bigger ball (and maybe even closer to the original drawing)
7
December 15, 2019
The wings and fuselage are now painted and decalled
8
December 15, 2019
I used some leftover FM decals
9
December 15, 2019
10
December 15, 2019
11
December 17, 2019
Wings attached - back end
12
December 17, 2019
Front side
13
January 13, 2020
14
January 13, 2020
15
January 13, 2020
16
January 13, 2020
17
January 13, 2020
18
January 13, 2020
19
January 13, 2020
20
January 13, 2020

Comments

15 December 2019, 11:06

JD
Zounds!

13 January 2020, 04:13

Torsten
😎 👍

13 January 2020, 05:03

Uwe Kaeding
Thanks guys

13 January 2020, 07:25

Album info

This is a pretty simple conversion of a Revell TIE Fighter into the ground support/superiority version as seen in one of the old Star Wars newspaper comic strips. I've used the Revell kit as a base as its the same size as a Bandai kit but a bit cheaper. It can be detailled with bits from a Bandai or Fine Molds kit but does need grooves cut into the wing edges as they are molded flat.

Star Wars: Imperial Fighters

233 images

1:72

In progress

1:72 Tie Defender Mk.1 (JBOT Decals R72-08-01)

12+

All albums

View all albums »