Thread started by playtime
playtime 222Calling anyone who owns any one of the boxings of this kit and a scanner. I've glued my wings together without opening the holes for the pylons. I would be very grateful if someone could scan the back of the kit part, either D1 or D2, and send me the pic?
10 February 2017, 18:37
playtime 222Bump. Well... any scan of a wing with the 2 pylon holes in? I can scale it down.
12 February 2017, 13:21
gorbySorry playtime I can't help, but when I did this a while ago, I found that shining a very bright light through the wing made the drill points visible. If you have tried that, at least this will bump your post to the top
12 February 2017, 16:34
playtime 222Not bright enough apparently! May have to take it apart and clean up any mess. What's the solvent for this again - liquid cemented pieces - brake fluid?
15 February 2017, 10:35
playtime 222I'm reading here (cs.finescale.com/fsm..s/f/13/t/147764.aspx) that cutting is my only real option...
15 February 2017, 10:37
gorbyThat's a shame, maybe the plastic is thicker than the kit it did it on. Good luck.
15 February 2017, 10:41