Thread started by hiveloc
hiveloc
added a new photoalbum.
added a new photoalbum.
15 images
Trumpeter/SPD T-62 Mod 19721:35
Initial base coat on- light at the end of the tunnel!
Project: T-62 Mod 1972 August 2008
18 15 March, 18:24
André Silva
Outstanding job on the fuel lines. I made them a few times but now I use aftermarket ones, yours are perfect.
Outstanding job on the fuel lines. I made them a few times but now I use aftermarket ones, yours are perfect.
3 April, 21:29
hiveloc
Thanks André! Lots of bending and testing as you know. I'm getting myself ready for the slat armor construction, and will definitely go with your tip of making a jig. I've been following YOUR T-62 build, and your anti-radiation cladding on the turret is awesome!
Thanks André! Lots of bending and testing as you know. I'm getting myself ready for the slat armor construction, and will definitely go with your tip of making a jig. I've been following YOUR T-62 build, and your anti-radiation cladding on the turret is awesome!
3 April, 22:34
André Silva
Thank you hiveloc. I'm now (with a pinch of salt) placing the turret slat armor supports. When it's done (hopefuly correctly), i'll share their detailed placement locations by lenght and height, so anyone trying the same build won't have the same trial, error and elbow grease experience. Also following your build.
Thank you hiveloc. I'm now (with a pinch of salt) placing the turret slat armor supports. When it's done (hopefuly correctly), i'll share their detailed placement locations by lenght and height, so anyone trying the same build won't have the same trial, error and elbow grease experience. Also following your build.
4 April, 15:00
hiveloc
The turret slat mounting is going to the top of my NOT FUN list! I had a sheet of paper full of measurements and helpful tips from @André Silva, but I still ended up spending too much time testing and fitting everything in place. An unfortunate tip-over during construction had me re-attaching some of the parts- sigh.
The turret slat mounting is going to the top of my NOT FUN list! I had a sheet of paper full of measurements and helpful tips from @André Silva, but I still ended up spending too much time testing and fitting everything in place. An unfortunate tip-over during construction had me re-attaching some of the parts- sigh.
25 April, 17:27