Mike Daniels
Absolutely agree Peter. The WnW instruction booklets are fab. A lot of very hard to find historical information that is difficult to find elsewhere.

I have been using 'Gorilla' CA. Works well for me. Had a little tube that must have so far done about ten models. It is not runny at all and gives you a few seconds to move things around rather than being an instant bond.

Peter Jenssen
I prefer it to cure fast. I'm using Zap thin CA. However, in drilled holes, it's a bit random how fast it cures. Sometimes it takes a minute or more, sometimes only seconds.
Trouble is, you can't tell until letting go of the line...
I had some issues with bonds cured with accelerator being weak, so I don't really trust it now.
Currently, I have resorted to working with a drop of glue on a piece of plastic that I have left out in the open for 15 minutes first.
Seems to be what works best for me so far...