Mobile 1 NSX (Job Log 2/2)

This is 6 times clear coat and flatting. 

Shunko decal was heavy thick. 

Good condition. 

The transparent paint fell off while painting, so I diluted it with a new one, but the dilution ratio wasn't right, so I quickly erased it with a tissue and repainted.
So, a little bit of lint remains, but it disappears during the polishing process. 

Polishing done. 

Clea 

I tried 6 times coating, but in the end, the flattening of the 'mobile 1' part of the wing and door was unsuccessful. 

I tried 6 times coating, but in the end, the flattening of the 'mobile 1' part of the wing and door was unsuccessful. 

Final mask work. 

Done. 

Panel lining with panel line accent color. 

Paint brushing with Vallejo. 

Varnish coat on wind shield decal for UV cut. 

Paint the gate cutouts with chrome color. 

Hasegawa sheet. (Stainless) 

All painting work is done. 

Assemble Engine. 

Engine mount to chassis. 

Assemble exhaust.
To level the end of the muffler, a tissue was inserted to secure it. 

Assemble bathtub. 

Assemble front drive train. 

Stick to tire decal. 

It is too glossy. 

Paint several times with very diluted 'Vallejo Mecca Varnish(Flat)'  

Detail-up harness. 

The decal and paper were cut and pasted on the shoulder cushion. 

Assemble all inner parts. 

Other view 

Other view 

Other view 

I attached the parts inside the body shell tightly. 

I put an Hasegawa sheet(Mirror Surface Finish) on the back.
No glue was used where it broken parts. 

Assemble nose. 

Tightly attach wind shield. 

This is metal ball (I can't remember ?mm) 

Insert the metal ball into the riveted hole. 

Same work. 

Metal decal of Hobby Design. 

Cover the body shell. 

Attach therear under cowl. 

Green arrow : Hasegawa sheet(red, flat black) 

Finish 

Finish 

I like this camera angle.