IDF Sherman Ambulance II
Legend conversion kit
sprues
sprues
sprues
sprues
sprues
sprues
a bit warped, think it is too much for glue alone
this area need to be removed from the bottom hull to place the overhang? seems like it according to the instructions, but looks weird
tried too straighten the walls with hot water
tried too straighten the walls with hot water
dryfit
dryfit
those tiny surfaces have to support the total tank, I don't trust it
gluing surface is only a few mm²
added some sprue, to drill some holes and add some copperwire. Still need to sad a bit so it looks more descent.
also in the suspension
Upper hull mated and started detailing
Upper hull mated and started detailing
some messy job still to do here
Comments
21 March 2018, 10:07
Bart GoesaertMade some work off the suspension and mated the upper and lower hull. The suspension is very flimsy (six bogey's with only a few square mm's as a glue-joint.) So I added a bit of material so that I was able to drill some holes and reïnforce it with copper wire. Still needs to be tidied up a bit. Friul tracks are also on the way. Manual says there that it should be a wire running completely through the track, but there is a length of wire left and right...
3 April 2018, 11:44
