MiG-15 bis
Out with the Alclad
A touch of masking
A lot of work for a single panel
Hope this is worth it
Think it’s called subtle colour diff
At the right angle it can just be seen
Decals settled down great
These decals from trumpeter are nice n thin
Temp fit of engine
Never get TET near Alclad ????
Wings on
Home made pitot
Never reach over model with glue as you are asking for trouble
Fixed
Raw material
Under construction
Ah might have made mistake painting but onwards
But of masking
All white now
Freshly marked
Finished and framed
Kommentarer
8 27 November 2019, 17:29
Sy BarSome progress but one step forward two back. Need to respray tail to fix mishap with TET
11 March 2020, 08:46
Sy BarThought I would have a go at laying a Russian concrete flight pan while waiting to finish kit
19 April 2020, 19:35
Sy BarThanks Neuling please with the quick base and most of the mig - made a few mistakes with it but none too obvious I think
22 April 2020, 17:48
Paul ChoudhuryJust starting this kit myself. Will refer to your excellent work often.
13 July 2020, 23:29
Paul ChoudhuryQuestion. How much weight did you have to stuff into the nose and where did you put it?
14 July 2020, 22:54
Sy BarPaul
If I recall about 15g, just be careful of placement I failed to notice when I creamed it in I'd prevented the halves from joining so had to remove and try again!
15 July 2020, 08:40
Alexander GrivonevThat is an awesome solution for the concrete baseplate, very nice 👍
The MiG is great too btw!
15 July 2020, 09:58
Paul ChoudhuryDid you have an trouble with the alignment and fit of the completed three-cannon assembly into the underside of the nose section? Mine just doesn't line up right and I'm trying to figure out a solution.
23 July 2020, 17:38
Sy BarPaul
It was always my intention to have the gun assembly lowered for maintenance so I acutually never tried to fit it in. Not sure how far the cannons pop out, could you try fitting a portion of them sticking out after fixing the outer panels in place?
It's the same with the rear I was always going to have the engine exposed so never had to Aline the rear to the front.
Hope you find a suitable solution 👍
24 July 2020, 05:34
Roland ZenhorstVeryt nice, the Mig is a fine looking aircraft and yours looks absolutely great. And i will be borrowing your idea for the base. Looks absolutely dead simple and very convincing!
24 July 2020, 09:16
Gary DahlströmVery engaging build, the presentation draws your eye right into those beautiful details.
24 July 2020, 10:44
