Bacheca

Jv
Butiful

Villiers de Vos
Beautiful work.

David Wolff
It's mostly a lot of test fitting. I was able to get drawings of the original including dimensions which helped. I made the mistake of accepting the trans kit instructions for some of the build steps and discovered that the front axle was 2.4mm too far forward. This was why I ended up scratch building the front springs. I use a lot of reference material (mostly from the internet) and draw to scale any parts I need to make. To take measurements I use a selection of steel rulers, compass and a micrometer as well as Tamiya tape for curved sections. I'll try and include some examples. I always wash the resin in warm soapy water and air dry. To paint I use Mr Surfacer as a primer - this helps show up any imperfections or bubbles in the resin and is also a filler. Larger holes I use either cyanoacrylate and accelerant, sanding straight away as it is much harder than the resin when fully cured. I also use Green Stuff and Mr White Putty. As the Mr Surfacer is a filler as well it dries quite evenly and only needs a light rub over with 2000 grade wet and dry sandpaper. I usually use Zero Paints over the primer as although they smell they airbrush well and are rapid drying.

Bozzer
Excellent information! I look forward to seeing this come together! I have a Mack F type, Diamond T, Mack R 700 and a few others, that escape my memory. I'll try not to chip in, and give everyone else a chance to comment. Thanks again buddy 👍