Hughes TH-55A Osage

Special Hobby | No. SH72016 | 1:72

Hechos

Marca:

Special Hobby

Título:

Hughes TH-55A Osage

Número:

SH72016

Escala:

1:72

Tipo:

Kit completo

Publicado:

1998 Nuevos moldes

Tema:

Hughes 300 » Helicópteros (Aeronave)

Marcas

Hughes 300

• D-HFAB

• G-SHCB

Hughes Hkp 5

Svenska Flygvapnet (Swedish Air Force 1926-now)

• 40
  1988

Hughes TH-55A Osage

航空自衛隊 (Japan Air Self-Defense Force 1954-now)

• 61317

US Army Aviation (1947-1983)

• 18126
  1964

Contenido de la caja

Bebedero de plástico, Piezas fotograbado, Resina (molde), Vacuforme, Película fotográfica, Hoja de calcas (al agua)

Línea temporal del producto

 

Special Hobby

1998

Nuevos moldes

Instrucciones

Descargar 1019Kb (.pdf)

Mercado

Intercambio y comercio privado

EUR 30.00

Contacte al vendedor

Nota: Los precios y la disponibilidad son sólo indicaciones. ¡Compruebe si el producto realmente coincide!

Revisiones de caja

Reseñas externas

Enlace roto

Internet Modeler

Revistas

FineScale Modeler | Volume 17 Issue 9

English (TOC: 16 lines)

November 1999

Comentarios

DavidS
I was presented with this kit many years ago. Never managed to finish it. In particular, I could not figure out how to attach the resin interior to the vacuformed body. Then again, I am not a skilled modeler.

Also, I found that the interior was not accurate. The instrument panel does not resemble the pictures I found on the internet.

In my opinion, this is not a kit for beginners.

2 May 2020, 07:23

Gertjan Zwart
Very nice little kit of a not too common modelling subject. The injection moulded parts (struts and tubular landing gear stuff) imho are oversized. Since they are all simple and straight, I replaced them by Evergreen plastic rods. Other injection moulded parts are gas tanks and engine lay out and these are usable. The cockpit interior is fairly basic and detailing is up to the modeller. The cockpit bubble consists of two vacuformed halves that line up vertically in the middle of the cockpit. I am by no means an experienced multi media- modeller but I had relatively minor problems cutting, trimming and glueing these pieces into an acceptable cockpit.

10 January 2013, 09:02