F-16C big set

For Tamiya

Black Dog | Нет. A48081 | 1:48

Факты

Фирма:: Black Dog
Заголовок:: F-16C big set For Tamiya
Число:: A48081
Масштаб:: 1:48
Тип:: Набор деталей
Тема:: General Dynamics F-16 Fighting Falcon » Реактивные (Авиация)

Предназначен для

Этот набор дополнения предназначен для:

Tamiya

2007

2008

2009

Магазин

Интернет-магазины

USD 69.22Нет на складе »

Альтернативные SKU для Black Dog A48081:
BDOGA48081 | BDOA48081

Заметка: Цены и наличие являются ориентировочными. Также проверьте, действительно ли продукт соответствует!

Oбзор содержимого коробки

Внешние обзоры

Мы не знаем об обзорах содержимого коробки F-16C big set (#A48081) от Black Dog.

hamptonracing
Just received my Big Set from Lucky Model. Typical Black Dog where it’s thrown into a bag and then inserted into a paint shaker just ot make sure that some pieces break off. One additional problem is that there are about 50 pieces in this set but zero instructions. I can probably sit down and figure everything out, but a simple set of instructions and a rough idea of where things go would be very helpful. Anyone have an idea whether instructions may exist somewhere online?
With that being said, the set appears to be very detailed and once I get it cleaned up it should be a very promising upgrade to the Florida Mako bird I’ll building.

1 9 May 2019, 20:16

Jorge Avila
I too just received my set that I have on my to do list. Let me know if you find anything.

24 May 2021, 21:23

hamptonracing
I was never able to find any instructions, but a great resource to figure out where everything goes is the Jake Melampy book "The Modern Viper Guide, 2nd Ed.". It is probably the best Viper reference I've ever seen and was invaluable in helping me to use the Blackdog set. With that being said, you'll have carefully measure where to cut the kit plastic in order to get the resin to fit. There aren't any guides for that, so it just takes a lot of patience and careful measurement. Good luck!

26 May 2021, 01:59

Falk Röllig
It's always challenging to find the right panel lines to cut out but the photos are a little help. Maybe you can also try to contact MP original master models, if he can give you some advice. m.facebook.com/pages..els-236571760139543/

26 May 2021, 03:24