Carlo
Watching to see how this turns out.

Ben M
👀

Robert Podkoński
Watching with interest - I have mine build "on hold" - I have noticed that either the side walls of the engines' shroud are to low, or the rear bulkhead (on which the exhausts are installed) is too high... What's your solution here?

Tzonglin Wu
Hi Robert,
I don't think I did a good job.
I just used cutting, sanding, puttying , and strong adhesive to find a way to stick them all together.
In fact, I am always in a state of wanting to give up. 😛

Robert Podkoński
Thanks for your reply, Tzonglin Wu 🙂 Your photos tell quite the opposite story...but I understand you well - I am back to this kit from time to time, attaching few pieces or sanding.., and then it resides quietly on a shelf for few days, or weeks...