Avro Vulcan B.MK2
I hope this is enough weight...she's really tail heavy.
Needed to sand some to make sure the wings are flush when joining the two halves.
The only place where putty was required is around the air intakes.
Lots of wheels...
Upgrading the refueling probe.
The build completed, time for primer.
Not impressed with the Humbrol Maskol, it didn't leave a clean line. Might also be the paint (Vallejo). Had to do a lot of touch up.
Went back to using blu tack on the underside for masking. Can't go wrong with it.
Size comparison, she's a huge lady.
Kommentarer
9 24 September 2020, 17:57
Sergej I
Following aswel 👍. Much better with blu-tac!
Btw, wonderful black gloss base and marbling.
The only masking fluid which won't pull paint in flakes is Gunze Masking Sol R, but it dries longer than blu-tac spaghetti application...
Alternative is also AK/MiG silly putty, my go-to masking stuff for camo.
Following aswel 👍. Much better with blu-tac!
Btw, wonderful black gloss base and marbling.
The only masking fluid which won't pull paint in flakes is Gunze Masking Sol R, but it dries longer than blu-tac spaghetti application...
Alternative is also AK/MiG silly putty, my go-to masking stuff for camo.
23 May 2021, 18:32