Mirage F1CR, first time with magnets for stores

Results of the first session playing with magnets for stores. I used 2x1 disc magnets, a 2mm pilot hole wood drill fit for manual drilling with a screwdriver holder, and of course a steel tweezers to pick up the magnets and put them in their place. 

Some black/white decals were included. Putting some black lines in the not yet covered parts and adding a few small red and yellow spots really livens up the pit. 

 

This one did not fit nearly as nicely as the Heller (Special Hobby tool) one that I did earlier. I did sand the canopy a bit this time (and the pilot's bum) to make sure it fits better