makett adatbázis | polc kezelés

Hughes TH-55A Osage

Special Hobby | No. SH72016 | 1:72

Boxart Hughes TH-55A Osage SH72016 Special Hobby

Okosságok

Márka:
Special Hobby
Cím:
Hughes TH-55A Osage
Szám:
SH72016
Méretarány:
1:72
Típus:
Teljes készlet
Megjelent:
1998 Új eszköz
Téma:
Hughes 300 » Helikopterek (Repülőgép)

Jelölések

Hughes 300

DE
GB
Hughes Hkp 5
SE Svenska Flygvapnet (Swedish Air Force 1926-now)
Hughes TH-55A Osage
JP 航空自衛隊 (Japan Air Self-Defense Force 1954-now)
US US Army Aviation (1947-1983)

A doboz tartalma

Műanyag rugó, Photoetched fret, Gyanta (öntött), Vákumformázott, Fotó film, Matrica (nedves)

Contents Hughes TH-55A Osage SH72016 Special Hobby

Termék idővonal

 
Special Hobby
Teljes előtörténet »

Útmutató

Letöltés 1019Kb (.pdf)

Piactér

Magánkereskedelem és csere

Jegyzet: Az árak és a rendelkezésre állás csak tájékoztató jellegűek. Ellenőrizd a termék tényleges eggyezőségét is.

In-box értékelés

Külső vélemények
Internet Modeler
Megszakadt link
Internet Modeler

Magazinok

(FineScale Modeler Volume 17 Issue 9)
FineScale Modeler | Volume 17 Issue 9
English (TOC: 16 lines)
November 1999

Hozzászólások

DavidS
I was presented with this kit many years ago. Never managed to finish it. In particular, I could not figure out how to attach the resin interior to the vacuformed body. Then again, I am not a skilled modeler.

Also, I found that the interior was not accurate. The instrument panel does not resemble the pictures I found on the internet.

In my opinion, this is not a kit for beginners.
2 May 2020, 07:23
Gertjan Zwart
Very nice little kit of a not too common modelling subject. The injection moulded parts (struts and tubular landing gear stuff) imho are oversized. Since they are all simple and straight, I replaced them by Evergreen plastic rods. Other injection moulded parts are gas tanks and engine lay out and these are usable. The cockpit interior is fairly basic and detailing is up to the modeller. The cockpit bubble consists of two vacuformed halves that line up vertically in the middle of the cockpit. I am by no means an experienced multi media- modeller but I had relatively minor problems cutting, trimming and glueing these pieces into an acceptable cockpit.
10 January 2013, 09:02