Hughes TH-55A Osage

Special Hobby | N° SH72016 | 1:72

Statistiques

Marque:

Special Hobby

Titre:

Hughes TH-55A Osage

Numéro:

SH72016

Échelle:

1:72

Type:

Maquette complète

Sorti:

1998 Nouvel outillage

Sujet:

Hughes 300 » Hélicoptères (Avions)

Marquages

Hughes 300

• D-HFAB

• G-SHCB

Hughes Hkp 5

Svenska Flygvapnet (Swedish Air Force 1926-now)

• 40
  1988

Hughes TH-55A Osage

航空自衛隊 (Japan Air Self-Defense Force 1954-now)

• 61317

US Army Aviation (1947-1983)

• 18126
  1964

Contenu de la boîte

Grappes de plastique, Photodécoupe, Résine (moulée), Formé par dépression, Film photo, Décalcomanie (à l'eau)

Chronologie du produit

 

Special Hobby

1998

Nouvel outillage

Instructions

Télécharger 1019Kb (.pdf)

Place de marché

Commerce privé et swap

EUR 30.00

Contacter le vendeur

Remarque: Les prix et la disponibilité ne sont qu'indicatifs. Vérifiez également si le produit correspond réellement!

Avis sur le contenu de la boîte

Examens externes

Lien rompu

Internet Modeler

Magazines

FineScale Modeler | Volume 17 Issue 9

English (TOC: 16 lines)

November 1999

Commentaires

DavidS
I was presented with this kit many years ago. Never managed to finish it. In particular, I could not figure out how to attach the resin interior to the vacuformed body. Then again, I am not a skilled modeler.

Also, I found that the interior was not accurate. The instrument panel does not resemble the pictures I found on the internet.

In my opinion, this is not a kit for beginners.

2 May 2020, 07:23

Gertjan Zwart
Very nice little kit of a not too common modelling subject. The injection moulded parts (struts and tubular landing gear stuff) imho are oversized. Since they are all simple and straight, I replaced them by Evergreen plastic rods. Other injection moulded parts are gas tanks and engine lay out and these are usable. The cockpit interior is fairly basic and detailing is up to the modeller. The cockpit bubble consists of two vacuformed halves that line up vertically in the middle of the cockpit. I am by no means an experienced multi media- modeller but I had relatively minor problems cutting, trimming and glueing these pieces into an acceptable cockpit.

10 January 2013, 09:02