seinä
Wall
June 3, 2024
June 2, 2024
May 31, 2024
May 29, 2024
May 28, 2024
Casey Beckett
haluaa tämän tuotteen
haluaa tämän tuotteen
PT-13/17 - N2S Cockpit Set
Starfighter Decals 1:72
7222 28 May, 02:04
May 27, 2024
Casey Beckett
aloitti tämän kohteen
aloitti tämän kohteen
Conversion set for HobbyBoss/Zvesda kit
Mil Mi-14PS (Haze-C) Ми-14 ПС "in coop. w. NeOmega" Resin magazin 1:72
72106 2016 Uusi työkalu 27 May, 18:32
May 25, 2024
Casey Beckett
merkitsi tämän tuotteen kaupallisesti / myytävänä
merkitsi tämän tuotteen kaupallisesti / myytävänä
25 May, 22:44
Casey Beckett
Will make package deal for kit, masks, Reskit rotor details and QB intake for $30.00
Will make package deal for kit, masks, Reskit rotor details and QB intake for $30.00
25 May, 23:01
Casey Beckett
merkitsi tämän tuotteen kaupallisesti / myytävänä
merkitsi tämän tuotteen kaupallisesti / myytävänä
L-749 Constellation - Heller Kit -
Brengun 1:72
BRL72160 myyty
25 May, 22:41
Casey Beckett
haluaa tämän tuotteen
haluaa tämän tuotteen
A-6 Intruder In U. S. Marine Corps Service and Navy Test & Evaluation Squ...
Colors & Markings Series No. 7
Rock Roszak, Mike Heideman
2023 25 May, 18:34
May 24, 2024
Casey Beckett
omistaa tämän kohteen
omistaa tämän kohteen
Yanks with Roundels - Part 4 Thunderbolt in RAF/SEAC service
Xtradecal 1:48
X48-115 20xx Uusi työkalu 24 May, 00:52
May 23, 2024
May 18, 2024
May 15, 2024
May 14, 2024
Casey Beckett
omistaa tämän kohteen
omistaa tämän kohteen
Slide Fit Pack 4 Pieces / 0.3-0.5-0.7-0.9mm 305mm Length
Albion Alloys
SFT2 14 May, 00:32
Casey Beckett
omistaa tämän kohteen
omistaa tämän kohteen
Aluminum Micro Tube Assortment - 305 x 0.3/0.5/0.7/0.9 mm (4 Pcs.) 0.1/0.3/0.5/0.7 mm I.D. (Respectively)
Albion Alloys
SFT4 14 May, 00:30
May 12, 2024
May 11, 2024
May 3, 2024
Casey Beckett
Got mine today -Looks like a BT-67.
Initial assessment , not too bad!
So, what I see - fuselage is stretched. Clear parts are rough,(pits and not clear) - but do install from the outside of the fuselage, so that's a plus. Sprue gates are in some not too good locations, (leading edges, sides of wing/belly center section, a few others will need some careful separation. Detail looks mediocre, but a good start. Instrument panel is flat. Yokes and rudder pedals are awful thick. You do get weighted or unweighted tires, a nice touch. Minimal flash, but it is there. Sink marks are few but large inside the fuselage. Full interior although simple. The tail cone on mine was separated from the spue, it looks to be tough to clean up. Small short part, 4 radii, and leading to a point.
Panel lines - well they certainly are THERE. Far too heavy, have not compared them for accuracy with a proper line drawing of the aircraft.
Decals look great, particularly the Australian and Canadian flags. The prop logos are bit out of register. Carrier film looks to be just the right amount.
Now the big question, which scheme? So many lovely options for this airframe! The 3 in the kit are all good. One BT with is based near me in Smithfield NC, purportedly for "paratroop training" terribly boring scheme on that one, all white with two lime green? or gold? cheat lines - rumor has it it's a government plane used by our three letter agencies. I am leaning toward the "White Desert " scheme of Theia Aviation.
A replacement windscreen is a must, it's just too thick and pitted. Shame there.
Got mine today -Looks like a BT-67.
Initial assessment , not too bad!
So, what I see - fuselage is stretched. Clear parts are rough,(pits and not clear) - but do install from the outside of the fuselage, so that's a plus. Sprue gates are in some not too good locations, (leading edges, sides of wing/belly center section, a few others will need some careful separation. Detail looks mediocre, but a good start. Instrument panel is flat. Yokes and rudder pedals are awful thick. You do get weighted or unweighted tires, a nice touch. Minimal flash, but it is there. Sink marks are few but large inside the fuselage. Full interior although simple. The tail cone on mine was separated from the spue, it looks to be tough to clean up. Small short part, 4 radii, and leading to a point.
Panel lines - well they certainly are THERE. Far too heavy, have not compared them for accuracy with a proper line drawing of the aircraft.
Decals look great, particularly the Australian and Canadian flags. The prop logos are bit out of register. Carrier film looks to be just the right amount.
Now the big question, which scheme? So many lovely options for this airframe! The 3 in the kit are all good. One BT with is based near me in Smithfield NC, purportedly for "paratroop training" terribly boring scheme on that one, all white with two lime green? or gold? cheat lines - rumor has it it's a government plane used by our three letter agencies. I am leaning toward the "White Desert " scheme of Theia Aviation.
A replacement windscreen is a must, it's just too thick and pitted. Shame there.
3 May, 01:23
May 1, 2024
April 30, 2024
Casey Beckett
omistaa tämän kohteen
omistaa tämän kohteen
Convair F-102 Closed Weapons Bay Doors for Hasegawa kit
Lone Star Models 1:72
70416 199x Uusi työkalu 30 April, 23:18
April 24, 2024
April 22, 2024
wnolder.php?lang=fi
2024-04-22 23:29:18
2019-01-12 20:44:03
46988
/ajax/wnolder.php?lang=fi&sd=2024-04-22 23:29:18&md=2019-01-12 20:44:03&filter=&w=46988
todo