Bugatti Type 35B Part 5 Body Panels Steps 29-34
Dash with all the controls added before body was installed
Right front panel alignments, you can see here that the French blue I used for the frame is darker than the molded color.
Right side panel align ment and gasket for shift knob
Rear lelt alignment and exhaust bracket
Front left alighment of panles
Left side body work overall
Comentarios
3 12 January, 22:15
Album info
I started attaching the body panels to the completed chassis. I decided to keep the molded color for the panels, so I polished them using Nexus 3 step polisher and a polish attachment to my Dremel. I wanted to make sure the panels weren't marred by excess glue so I test fitted each panel first and then a bead of Faller Expert glue to the inside seam of the panel. I then touched any seams up with Tamiya extra thin cement. I had to clamp the rear body part during this process to make sure the seams were tight to the lower body assembly, I also installed all the dashboard switches and knobs before I put the body on. I was amazed at the excellant fit and alignment for all the panels and access points for future assembly
(Result: 2nd)