Zimmerit Coating Sheet for 1/35 Scale Elefant
Tamiya
Tamiya | No. 12644 | 1:35
Fakta
- Značka:
- Tamiya
- Název:
- Zimmerit Coating Sheet for 1/35 Scale Elefant Tamiya
- Číslo:
- 12644
- Měřítko:
- 1:35
- Typ:
- Detailní set
- Vydáno:
- 2012
- čárový kód:
- 4950344126446 (EAN)
- Obal:
- V pytlíku
- Téma:
- Sd.Kfz. 184 Ferdinand » Stíhače tanků (Vozidla)
Obsah krabice
Obtisky (samolepky)
Rozměry:
330x135x1 mm
(13x5.3x0 inch)
Hmotnost:
20 g (0.04 lbs)
Navrženo pro
Doplňková sada pro:
Tamiya
2012
Nová formaObchod
Internetové obchody
USD 6.99
Na skladě »
USD 8.79
Na skladě »
USD 8.80
Na skladě »
USD 9.35
Na skladě »
USD 10.50
Na skladě »
USD 11.00
Na skladě »Zobrazit všechny nabídky » (17 celkem)
Alternativní SKU pro Tamiya 12644:
74-T12644 | 4950344126446 | 300012644 | HC_12644 | TAM12644 | TAM-12644
Poznámka: Ceny a dostupnost jsou pouze orientační. Zkontrolujte také, zda se produkt skutečně shoduje!
In-box recenze
Externí recenze
Reklama
Posouzení
AMPS
Posouzení
IPMS USA
Projekty
Komentáře
Jens AndréeI have mixed feelings about this zimmerit sheet. The quality was great! No doubt about it - BUT there's no excuse to not cutting the pieces with a laser cutter or knife plotter my Tamiya. Cutting out the pieces wasn't too hard, but all the little holes that needed cutting was a different story... I eventually resorted to using small PCB drills to cut the holes needed, but perfect it wasn't and unless Tamiya starts to pre-cut the individual pieces I won't do another zimmerit sheet. Just my opinion.
4 July 2017, 01:13
Holger KranichHi Jens,
i have this sheet too and i am not very amused, too. And i experienced that in corners or edges the glue dont stick enough. And for the holes, you have to take a punch and die set.
BTW welcome to scalemates!
Cheers Holger
4 July 2017, 06:35
Jens AndréeI badly wanted a punch set when I discovered that you had to cut all those holes in the sheet, but they are sadly missing from my otherwise extensive "toolbox", but brand new PCB drills did the trick - but it was slow and required more than a few breaks in order to "cool down"...
I've been lucky so far with my zimmerit still sticking well to the model, but I made sure not to touch the sticky side prior to placing them and I hope it'll work in the long run? I'd be a bit upset if they start to peel off in a year or so... Regardless, unless Tamiya pre-cuts these zimmerit sheets I won't ever use them again. Not fully thought through if you ask me - but they look fantastic when done!
Thanks for you kind comment!
4 July 2017, 20:25
Referenční materiál
Všechny knihy » (14 celkem) Všechny walkaroundy » (3 celkem)