A-20G Hacoc 1/72 "La France Libre"
The original plastic cockpit is so simplified that I strongly recommend checking the PE set in the box or you may buy it on aftermarket.
The worst fitting in this kit. I have to cut out the floor about 2mm, on both sides...Then clear out the excessing details on the walls.
After that, the upper seam is acceptable for fitting the nose part.
Dry-fit is a must.
Dry-fit is a must.
At first, I thought the gear/engine bay can be glued before the gears so. It's NOT.
Engines are well cast, so they deserve adding more details. 🙂
Some of these invasion stripes will be covered by OD.
revealed
Enlightened. I think there was a little bit too dark on the upper side.
Decals were good!
Gray line is much more better, yet I believe that I should do more enlightening on panels
Enlightened, again.
Exhausting
Almost there
Almost there
Propellers' on.
Copper wire is not good enough, I have brought elastic wire for 1/700 ships, just wait.
Note here: The intake above the engines have to scoop out,otherwise they were solid plastic.
Коментари
57 9 April 2022, 03:11
Cuajete
I think it's the first time I've seen a pre-paneled in blue. Interesting...
I think it's the first time I've seen a pre-paneled in blue. Interesting...
16 April 2022, 10:07
Harvey H.W.
Cuajete: For olive green , pre-shade with blue may presenting a darker, colder green. Another funny reason is I have some surplus storage of this colour. 😄
Cuajete: For olive green , pre-shade with blue may presenting a darker, colder green. Another funny reason is I have some surplus storage of this colour. 😄
16 April 2022, 12:03
David Januska
Nice job and perfect result so far👍. I am sad that fit is not so good I have also this one in my stash. Congratulations.
Nice job and perfect result so far👍. I am sad that fit is not so good I have also this one in my stash. Congratulations.
22 April 2022, 17:23
Jose Freire
Like the effect you got with the pre-shading in that unusual color. Will try it in one of my next projects. Great job so far.
Like the effect you got with the pre-shading in that unusual color. Will try it in one of my next projects. Great job so far.
22 April 2022, 22:06
Harvey H.W.
Thanks Newling, Alec, Kyle and other mates!
Here are 2 pics update about engines' details. Again, thanks for watching and all your warm supports. 🙂
Thanks Newling, Alec, Kyle and other mates!
Here are 2 pics update about engines' details. Again, thanks for watching and all your warm supports. 🙂
5 May 2022, 14:20
Michael Kohl
Built with standard procedure? You achieved your standard result - which is way above average. 🙂 Well done, mate!
Built with standard procedure? You achieved your standard result - which is way above average. 🙂 Well done, mate!
5 May 2022, 14:22
Album info
Hi everyone! When I was waiting materials for my carrier elevator. I decided to open a MPM kit of A-20G. To be honest, the fitting of this kit is quite disappointing, yet a piece of Eduard's coloured PE is a plus.
This project will go on with standard procedure. Have fun.