DH. 82A Tiger Moth SPACE
ICM
Eduard | No 3DL32002 | 1:32
Факти
- Марка:
- Eduard
- Наименование:
- DH. 82A Tiger Moth SPACE ICM
- Номер:
- 3DL32002
- Мащаб:
- 1:32
- Тип:
- Набор за детайлиране
- Баркод:
- 8591437557837 (EAN)
- Тема:
- De Havilland DH 82 Tiger Moth » Пропелер (Самолет)
Съдържание на кутията
Фотоец (Multi-colored), Decals (3D) (Multi-colored)
Какво има в кутията »Инструкции
Изтегли 3729Kb (.pdf)
Пазар
Онлайн магазини
USD 11.96
В наличност »USD 12.39
В наличност »USD 13.49
В наличност »USD 10.49
Наличен »AUD 17.50
USD 12.40В наличност »€ 8.98
USD 10.43В наличност »Покажи всички оферти » (12 общо)
Алтернативни SKU за Eduard 3DL32002:
EDU3DL32002 | ED 3DL32002 | ED3DL32002 | 7397102
Забележка: Цените и наличността са индикативни. Проверете дали продуктът действително съвпада!
Преглед на съдържанието
Външни прегледи
Реклама
Коментари
Kenneth
I have bought this for my Revell re-pop of the 1/32 ICM Tiger Moth. It‘s very nice, but I do notice the following issues:
1) The lap belts are attached to the lower-most fuselage longerons, not halfway up the fuselage.
2) There are three throttle levers, but only two are shown in the instructions. The third one could be used as a mixture lever, but then only in the rear cockpit.
3) The harness locking pins and spring clips are too large and unrealistically two-dimensioal. Moreover, they are attached by strings to the shoulder belts, not the lap belts.
4) The shoulder belts are not directly attached to the panel behind the seats, but to a steel wire running in the indentation in each panel.
5) The upper edge of the required cut-out in each instrument panel for the compass should be curved, not straight.
It would be worthwhile checking some of the many walkarounds in the Internet, before using this set
I have bought this for my Revell re-pop of the 1/32 ICM Tiger Moth. It‘s very nice, but I do notice the following issues:
1) The lap belts are attached to the lower-most fuselage longerons, not halfway up the fuselage.
2) There are three throttle levers, but only two are shown in the instructions. The third one could be used as a mixture lever, but then only in the rear cockpit.
3) The harness locking pins and spring clips are too large and unrealistically two-dimensioal. Moreover, they are attached by strings to the shoulder belts, not the lap belts.
4) The shoulder belts are not directly attached to the panel behind the seats, but to a steel wire running in the indentation in each panel.
5) The upper edge of the required cut-out in each instrument panel for the compass should be curved, not straight.
It would be worthwhile checking some of the many walkarounds in the Internet, before using this set
21 January, 10:37
Материал за справка
Building the ICM D.H.82A Tiger Moth in 1/32 Scale
Build Guide Series No 19
Max Williams
2023 Дигитален Всички книги » (12 общо) Всички walkarounds » (6 общо)