Thread started by PK99
PK99
added a new photoalbum.
added a new photoalbum.
All comments (7) » 11 April 2019, 01:27
Michael Phillips
Yep, as above. Having completed this conversion, I must say the resin parts fit very well if you cut along the correct lines on the kit. I was very impressed. The negatives I have are the panel lines in the resin shoulders are quite deep and do stand out a little compared to the rest of the HB plastic. One of my vertical tails had a very slight bend on the very top fin cap portion, and there was a small chip in the fin cap trailing edge of the other. The tail detail is very delicate there. Handle the tails in particular with extreme care.
Yep, as above. Having completed this conversion, I must say the resin parts fit very well if you cut along the correct lines on the kit. I was very impressed. The negatives I have are the panel lines in the resin shoulders are quite deep and do stand out a little compared to the rest of the HB plastic. One of my vertical tails had a very slight bend on the very top fin cap portion, and there was a small chip in the fin cap trailing edge of the other. The tail detail is very delicate there. Handle the tails in particular with extreme care.
11 April 2019, 17:50