Thread started by JohnVK
John Van Kooten
owns this item
owns this item
All comments (24) » 4 October 2015, 06:55
John Van Kooten
It's a thread for all of us 😉 so no problem whatsoever! 👍
I have made a first draft of a 3D model to replace the incorrect Tamiya part, that I may send off to Shapeways to print. Depends on whether it will be actually printable and what it will cost when it's done. I am going to have to make some test prints to see if it fits the kit, so it could become quite costly real quick. About €10 in the current state of the 3D model for each 3D print.
More info here, with some test renders of the 3D model, which obviously still needs quite a bit of work:
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
It's a thread for all of us 😉 so no problem whatsoever! 👍
I have made a first draft of a 3D model to replace the incorrect Tamiya part, that I may send off to Shapeways to print. Depends on whether it will be actually printable and what it will cost when it's done. I am going to have to make some test prints to see if it fits the kit, so it could become quite costly real quick. About €10 in the current state of the 3D model for each 3D print.
More info here, with some test renders of the 3D model, which obviously still needs quite a bit of work:
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
Assorted Images for use in my posts | Album by JohnVK
14 October 2015, 21:19