This kit also had a lot of extra parts. Almost all the optional/extra parts were not on the induction sheet. Most were common sense on what it was but a couple were not and I have no clue what it could be.
Wired the engine. Wanted to make it look cool and have the wires seen well. I did not go for realism on this build. Just whatever looked cool. The Distributor I used is an aftermarket part. the one that came in the kit was too small to add wires to.
This was my first time putting in bullet holes. I made some bigger than I wanted to but overall, I'm good with the results. I painted Tamiya Pure Red lacquer over a light grey primer. Next is the paint the gloss black.