databas för modellbygge | samlingshanterare
Dizzyduck
David H (Dizzyduck )
GB

Colonial Navy

Kommentarer

50 30 October 2021, 18:20
Sergej I
Funny scheme 😄 Watching 👍
16 November 2021, 13:05
Augie
i'm in watching
17 November 2021, 17:06
David H
I'll try to make it an interesting ride !😉
17 November 2021, 17:09
Nathan Dempsey
Watching 👀 Great idea 🙂
17 November 2021, 19:58
Dave Flitton
Watching!!!!!!!!
17 November 2021, 20:27
Maciej Bellos
In!
17 November 2021, 20:40
David H
The more I look into this the more work I find. The tail decals are too large and are going to need some "creative adaptations " 🤣
17 November 2021, 21:08
David H
Oh, and welcome to the the party guys !!
17 November 2021, 21:08
Gareth Windsor
Pulling up a seat David. I love the story behind this aircraft. I spoke to someone who was there and apparently the Commanding Officer blew his top when he saw what the Americans had done to one of his aircraft.
18 November 2021, 14:12
Augie
Well 892 had done the tail of a US Marine jet earlier.;..
18 November 2021, 14:34
David H
😆😆if you look carefully at photo 5 , you'll see that all 3 were in various stages of , how shall we say, adornment 😂
18 November 2021, 19:21
Augie
This

[img1]
 
18 November 2021, 20:35
Maciej Bellos
Augie I think this Marine Phantom was disguised as a British one because the Royal Navy carrier it was on, had to dock in Malta. There would be a diplomatic incident if there where to be an American plane in Malta. So it was a necessity, hastily and crudely performed.
18 November 2021, 22:55
Augie
Yeah I know Maciej 🙂 I'd heard the plan was they were going to stick it below decks.. couldn't fit it so sprayed it.. much to the Marines surprise.

One of those banter stories that over the years that it was a tit for tat zapping.

Like this one [img1]
 


Which resulted in

[img1]
 
18 November 2021, 23:26
Augie
And Maciej, I fouind the story behind the US Marine phantom with the 892 sqn tail..

"Ark Royal cross decked with USS Forrestal in the Med about 1973, and had a couple of F4's from VMFA-531 operating for a few days. Came time to go into Grand Harbour and one F4 went U/S, and went U/S and went U/S as we came very close to Dom Mintoff's anti-USA dominion. The only solution was to strike the offending machine into the lower hangar away from prying eyes whilst we were in Malta.

After a couple of days it was snuck into the upper hangar and repaired by 892, who had this really nice tail fin colour scheme. A few days before we departed Valletta a light grey RN F4 appeared on deck to carry out ground runs, with brown paper stuck just where USMC markings might have been

Within 2 hours of clearing the harbour, VMFA-531 CO's personal airplane was returned with one of the best zaps: so good, he took it all the way back home"

Sorry for thread hijack.. 🙂
18 November 2021, 23:43
Mark
Great anecdote @Augie. 👍
18 November 2021, 23:50
David H
Anecdotes like this are always very welcome, and are one of the great things about this hobby.😎 👍🏻
19 November 2021, 07:27
Robert Podkoński
Thank you, Augie, for sharing this story...and these photos, I believe (and I hope) there will be someone to paint a Harrier model in this "special" livery 😄
19 November 2021, 09:34
Dean Harpster
That is a great story, never heard that one before!
10 December 2021, 00:42
Jos Jansen
Interesting stories(s)...watching this one David, great start! This Revell, a Hasegawa rebox is fun to build with almost no problems, only some intake fitting issues.
8 January 2022, 08:42
David H
👍🏻 No real issues so far apart from I think mine is a poor pressing, with plenty of flash and very soft to non existent and variable surface detail..
8 January 2022, 08:54
Thomas Bischoff
I join the show as well! Would like to build this also one day - hoping for a new mould however
9 January 2022, 09:35
David H
I'd love a new mould fg1/2 but sadly I don't think there's enough interest. But I could be wrong 🤞
9 January 2022, 15:23
Gareth Windsor
There's a whole conversation right there David. I think there is a want for the FG.1 (F-4K/M) which is why RAM and Master Decals produce the after market decals and newer companies like Reskits are making detailed Spey exhaust cans. The problem really is that almost every Phantom has the same airframe, so produce a regular Phantom and you've created and covered a lot of subjects. The Spey is just British (the Canadians almost bought it) and you might not get a big enough profit margin to warrant your efforts. Thank goodness Revell love a good re-box.
10 January 2022, 14:16
David H
The problem as I see it, whilst there may be interest , there's not a lot of variation in what can be done with markings etc, so it becomes a bit of a one trick pony… sadly, never mind thanks be to Revell for at least keeping this going
10 January 2022, 17:00
Gareth Windsor
I posted the question of a FG.1/FGR.2 on a "Models for Manufacturers" page. Apparently Zoukei-Mura SWS are looking into it as part of their Phantom series. No doubt driven by Tamiya's new 1:48 offering.
11 January 2022, 13:26
Sergej I
Technology and virus work hand-in-hand in favor of modelers! 👍 😄
So many new and top quality models that are coming out... no doubt that also a FG.X will see the light of the day... I mean, I would consider Avro Anson a far more niche model...
11 January 2022, 14:41
Augie
My only grumble, is that there are soo many that have not been done yet and yet we keep getting new molds where there aleady existing kits.. 🙁 I know seems ungrateful, but there are some really great aircraft everyone would love that just have not been done.
11 January 2022, 14:45
Sergej I
Augie, 3D printing tech is improving monthly. I could imagine that there will be business in selling 3D data for such airplanes. We already have that with scale figures.
Imagined in Australia, designed in Vietnam, downloaded and printed in Slovenija 😄
No more stash 😮
11 January 2022, 15:01
David H
And those that have tried (good on them for trying) have, unfortunately, made a right royal pigs ears of it with poor research. Luckily I got my cougar before kitty hawk went belly up ..
11 January 2022, 15:02
Dean Harpster
Amazing work on the cockpit, very impressive!
18 January 2022, 00:40
David H
Thankyou Dean , that's very kind.
18 January 2022, 07:13
Robin (WhiteGlint)
Looking very nice 👍
7 March 2022, 08:30
Neil
I agree! 🙂👍 Following from here 👀
15 March 2022, 23:28
Vincent
Great work until now!!!
16 March 2022, 10:12
Guy Rump
Looking good 👍
25 March 2022, 19:47
David H
Ok, I swear this model is jinxed. I'm now onto my third set of decals and third respray of the rear end. They have just not settled properly. I've now decided to spray the red and just add the omega as a separate decal.
29 March 2022, 13:41
David H
I've decided this one's going to the shelf for a bit. Let's start something new as this is killing my mojo
29 March 2022, 13:43
Michael Kohl
sometimes a rest on the shelf is necessary. We are looking forward for the final steps
29 March 2022, 14:04
David H
Cheers Michael. I'll give a couple of weeks 👍🏻
29 March 2022, 14:05
Gareth Windsor
So frustrating mate. I'm having a similar issue right now with one decal position on a wing. Grrrr 😖
30 March 2022, 03:46
David H
Thanks for the support mates 👍🏻 Much appreciated and will definitely help with fg1 part2 , return of the mojo ..
30 March 2022, 09:43
tyu
ResKit instructions are in my experience far from complete unfortunately. Just fit any ResKit item before completing kit assembly is my advise. I don't get what is wrong with the tail decoration size in pic 22/23: painted area seems the same as decal area. Are the Xtradecal items oversized? Or a case of decal application going wrong?
30 March 2022, 09:58
David H
Hi tyu, and welcome

The decals come as one piece with red white and omega and are way oversized. What you see is the decal AFTER I have cut it into 3 pieces and resized the individual parts by trimming the edges , then aligning them so they match each other again. When my third set arrive I'll upload a comparison picture.
30 March 2022, 10:07
tyu
Thanks for the answer, confirms my feeling about Xtradecal: most of the times they seem to be not quite correct, proceed with caution.
30 March 2022, 10:21
David H
So , this has been staring at me across the desk now for a while and I think I have enough desire to restart it. I've added photos comparing the fin decals as they come as as they should so you can see the mess that xtradecal have made of these.
17 April 2022, 19:52
Robin (WhiteGlint)
Your work on the tail really paid off. 👍
24 April 2022, 20:16
Thomas Bischoff
Glad you fixed it! Your experiences with the Xtreadecals made me buy yesterday from an IPMS mate the Aeromaster Decals.
Now I only need a nice FG kit 😊
25 April 2022, 05:56
David H
The rest of the decals aren't that bad with good opacity and register, but these tail flashes really are a deal breaker. Just shows poor research. TBH I have the hasegawa set for the Marines F4, and they "look" oversized as well, but I won't know until I try to use them.
27 April 2022, 09:48
Gareth Windsor
This popped up on FB today. We know the story by now, but a better colour picture of the "zap" CO's aircraft.
m.facebook.com/NavyW..type=3&source=48
2 May 2022, 00:18
David H
Yup, that's going in my library .. thanks for pointing it out 😁
2 May 2022, 10:25
Dean Harpster
I love this unique subject! Beautifully done, those exhaust cans look great and the colors are very striking. Glad to see your frustration with the tail worked out looking great in the end!
13 May 2022, 23:32
David H
Thankyou Dean, that's very kind of you. I've got my enthusiasm back a bit.. just finishing my lanc, then back to this properly
16 May 2022, 20:55
bughunter
Oh yes, looks nice 👍
24 May 2022, 09:12
Andreas Lux
This is a beautiful bird and a very beautiful model! Great Job👍
14 October, 18:13
David H
Thankyou Andreas. Unfortunately over a period since these photos were taken the paint developed some serious crazing and cracking which I couldn't ignore any longer. Soon to be the subject of another thread..
14 October, 18:20
Andreas Lux
This effect of paint is definitely annoying, but that doesn't detract from the great result of your work!
14 October, 18:35
Guy Rump
Great job, sorry to hear about the paint issues afterwards. 👍
14 October, 19:55

Album info

We'll be building the venerable Hasegawa kit in the guise of Revell. As I couldn't get an FG1 I'll be converting the Revell FGR2 to a Royal Navy Spook after it cross decking "repaint "

48 bilder
1:48
Pågående
1:48 Phantom FGR. 2 (Revell 04962)1:48 McDonnell-Douglas F-4K Phantom FG.1 (Xtradecal X48186)1:48 F-4 British Phantom FG.1 Landing Gear (Scale Aircraft Conversions 48081)5+

Group Build

F-4 Phantom II Group build 2022 in
F-4 Phantom II Group build 2022

1. Januari fram tills 31. December 2022

All albums

View all albums »