banco de dados de modelismo | gerenciador de estoque
FloriM
Florin Moldovan (FloriM)
RO

Takom March 1945 Tiger Ausf. B with interior

Album image #1
Album image #2
Album image #3
Album image #4
Album image #5
Album image #6
Album image #7
Album image #8
Album image #9
Removed the inaccurate turbine looking fan and replaced it with a part from a Dragon Panther G smart kit 
 

Album image #10
Will go with minimal weathering, this represents the last King Tiger that was built and as such it did not travel much or did much 
 

Album image #11
Album image #12
Hull without the ammo racks 
 

Album image #13
The C shaped guard of the coaxial MG was severely undersized, it was filed off and replaced. It should protrude 1.5 mm from the armor face 
 

Album image #14
IMPORTANT As they are, the sockets for the 2 tonne crane are in the pre-9th of August 1944 configuration. If you make a replica of a vehicle that was built after this date, said sockets should be carefully cut with a razor saw and moved on the bumps marked by red circles (this is not mentioned in the instructions). If you build a vehicle earlier than 9th of August 1944, the circled bumps must be removed 
 

Album image #15
The crane sockets were moved to this new position because, when in place in the old position, the crane prevented the loader's hatch from opening 
 

Album image #16
To reflect the fact that in real life the hull roof was made from three (40 mm thick) armor plates, three weld lines must to be added. Errata: instead of 5.3 cm (53 mm) the correct figure is 50.3mm or 5.03 cm measured from the inner edge of the upper front armor plate 
 

Album image #17
About to replace the molded-in wire on the gun mantlet with one made from stretched sprue 
 

Album image #18
Had to drill a couple of 2 mm holes on the rear face of the gun mantlet. After cleanup hex bolts will be added in said holes. This missing detail is present in similar Hobby Boss and Meng kits 
 

Album image #19
The ABYSMAL Takom Ammo racks were replaced with ones from a Meng KT interior set (SPS-037). Test fit shows everything is OK. Now to paint! 
 

Album image #20
Fitting the Meng ammo racks to the Takom hull is easy, you just have to shave off the locating tabs for the Takom Ammo racks. To ensure a strong plastic on plastic bond, pieces of Evergreen strip were glued on the underside of the Meng ammo racks 
 

Album image #21
Album image #22
Hull interior is done 
 

Album image #23
The turret basket is from the Meng King Tiger interior set. The parts are vastly superior to their Takom counterparts and they fit on the major Takom parts with minimum modification
 
 

Album image #24
Bottom of the turret is Takom, the detail parts are from Meng.
A remark on the interior paint for the turret - the last ten turrets built by Wegmann had white paint instead of the regular Elfenbein
 
 

Comentários

3 27 June 2020, 17:16
Treehugger
Interesting detail about the additional three weld lines in photo 17.
7 July 2020, 09:24
Florin Moldovan
Hope that someone might find this useful. Also if there are mistakes, someone please point them out.
10 July 2020, 18:10

Project info

24 imagens
1:35
Em progresso
1:35 King Tiger (Takom 2073S)

Todos os álbuns

Ver todos os álbuns »