Logo
scale modeling database | stash manager
PetroAlchemist
Marc Schnitzler (PetroAlchemist)
DE

Academy Graf Spee

Album image #1
Album image #2
Album image #3
Album image #4
Album image #5
Nearly Done 
 

Album image #6
Added the Fake-wave and a bit of rust 😄 
 

Album image #7
Album image #8
Album image #9
Album image #10
Album image #11
Album image #12
Album image #13
Album image #14

Comments

6 October 2019, 14:15
Treehugger
You can probably knock down some of the paint edges along the masked water line, very carefully with fine sanding paper, before adding a gloss coat, otherwise, maybe leave it, as sanding paint will require adding a gloss coat to look ok again. There is also a danger of sanding through the paint if you also sand the flat areas with thinner layer of paint, which is ofc undesirable.
6 October 2019, 14:41
Martin Oostrom
Mmm. I've got this one as well, somewhere on my shelf of half finished. Perhaps I can find some inspiration here?
6 October 2019, 15:57
Marc Schnitzler
Thats a good idea, i think i will give it a try 😄
You think 1500er Sandpaper can do the Job?
I added my inspiration for my one in this Album😉
6 October 2019, 16:33
Treehugger
I am not sure. Also, best add some masking tape around the hull, so you don't scratch the paint elsewhere. As I commented before, I am assuming that you will add a gloss coat, else, probably not a good idea, sanding plain paint tend to look, bad.
6 October 2019, 16:48
Marc Schnitzler
Later i saw these Edges comes from the Hull Part, maybe the mark to cut the Hull for a waterline model.
10 November 2019, 16:10

Project info

14 images
1:350
In progress
1:350 Admiral Graf Spee (Academy 14103)

All albums

View all albums »