September 1, 2021
Tip: Best to always check the individual styrene strip/rod, as there might be some irregularities, best to spot those before you glue those pieces on. I've seen some bad stuff both with Evergreen and Plaststruct products, but not often.
ok, thanks for the heads up.
There are three issues I wanted to point out that I've seen: 1) crushed styrene (easily seen), 2&3) round rods not being round, rods or strips not having equal width, which can be bad because you don't want to sand a 20 cm strip of strip or rod to make it symmetric.
August 25, 2021
August 22, 2021
August 20, 2021
July 31, 2021
July 24, 2021
July 23, 2021
July 17, 2021
What dimension goes in length, height and width?
Maybe we should have a diagram in these fields to advise direction of dimensions
SCM Topic: Lighting
We have Nano LED lights used for incorporating into our builds and also LED lights or other lights used to illuminate our workbenches - to my mind these should be separate topics.
Maybe we already have a split but we are all getting confused what goes where?
Comments /suggestions ?
July 7, 2021
In the History section would it be possible to move certain images to the box content image overview.
At the moment when you replace an image with boxart you have to find a similar image and save that to your hard drive and then upload to content overview. So you end up searching for 2 images and not just 1.
Here is an example of one I set up where I replaced a content type image that was sitting in Boxart with proper boxart. The superseded image is now sitting in history - this image could serve as the content overview.
Bending Pliers (for Photo-etched Parts) (Tamiya 74067, No)
A more complex request (additional to above) would be to request images transferred to sprue detail - especially with photoetch. I am currently changing a lot of Eduard PE images to box art and then uploading the image that was in Boxart as the representative image for the sprue detail and if only 1 sprue the content overview as well.
Leaves Locust tree / Akát (Eduard 35717, 1:35)
June 19, 2021
June 7, 2021
June 3, 2021
SCM Topic: Reference books (Cross topic Vehicles)
May 30, 2021
May 26, 2021
May 25, 2021
May 22, 2021
May 2, 2021
April 14, 2021