Vickers Wellington MK.III

1
June 19, 2018
Chopped out a huge section of cowling to reveal the engine, Ignition wires were also added.
2
June 19, 2018
Side view of the now revealed engine
3
June 19, 2018
Exhaust, Ignition ring, and back wall shown
4
June 19, 2018
Front Turret, very nicely detailed, the Montex masks were extremely accurate and worked well. One note, don't pull on the monte masks once they are on, the adhesive pulls off easily and leaves harsh smears.
5
June 19, 2018
Rear view with some wear added.
6
June 19, 2018
Rear view with some wear added.
7
June 19, 2018
These are moulded in clear, but are black on the real aircraft. Thought I would take a snap because it looked so nice!
8
June 19, 2018
The panel was interesting too, the visible front panel is all clear, with a clear film of dials behind, and a plastic backing plate. I painted the backing plate white, stuck the dials on top, and then masked the panel with maskol blobs (Dials) and painted
9
June 19, 2018
10
June 20, 2018
Various radio parts for the wall behind the pilot.
11
June 21, 2018
12
June 21, 2018

Comments

2 19 June 2018, 15:52

Björn Svedberg
Interesting model! Really nice engine build! 👍 I'm in too. 🙂

19 June 2018, 20:02

Tom Yeoman
Thanks guys! I will keep you updated!

20 June 2018, 13:25

Björn Svedberg
Looks like a really nice kit, I like the detail level. Is it all out of the box?

22 June 2018, 07:53

Tom Yeoman
Hi Bjorn! Yes so far its all out of box, I added the wires on the engine, and some Eduard seatbelt in the pilots seats. it is a really nice kit! Ill post more photos this weekend.

26 June 2018, 15:59