Italeri's UH-1N Twin Huey in 1:72 scale

This kit's interior seem fairly crisp and nice I think. 

there is a small kit part for the inside of the large air intake, but I couldn't make it fit, so I added some styrene. Should look nice after cleaning this up I think. 

I like thinning the parts, to avoid everything looking like it has ~1mm thickness. 

I think this looks sort of nice for a 1:72 kit. Some putty is needed here and there for the larger parts. The large front canopy clear part (not shown here) isn't 100% clear, which is a shame. Oh, I must remember to scratchbuild the door handles, because those do like door handles in real life. 

I would like to think I am getting better at this. I left the center line in, so that I can see where it is. I removed all the detailing, to get to remove the two wipers that was molded (ohffs) into the clear part. I started with a 'medium' sanding stick dry, then wet with sponges 1500 and 3000 grit, and then wet with 4000, 6000, 8000, 12000 and then Tamiya coarse, fine and finish polishing compound. 

Looks ok to me. Not 100% though, because I can still see some tiny scratches around the corners. 

There is no mentioning of any nose weight, but I added some, just it case adding nose weight might be important. There aren't many places to add nose weight, so I put some tiny metal balls inside the hollow control panel, and some more under the floor.