Treadwell Repair Droid

This is a 3D printed kit of the Treadwell droid from the original Star Wars. Made by Figureworks (I think they are only on Facebook), its a nice simple kit but it was a limited run, so I'm not sure if its still available. I made some modifications to it as I didn't like the way the treads were molded to the main body. It was built mid last year but I only just took the final photos.

1
January 13, 2020
Primed and sanded main body
2
January 13, 2020
Primed superstructure, arms and head pieces
3
January 13, 2020
The rollers and treads were printed attached to the side of the body, and you couldn't see through the treads below the main body. Therefore I cut the treads off both sides, sanded them back and opened them
4
January 13, 2020
Comparison of opened out tread to the other just cut off the body
5
January 13, 2020
The body is hollow, with no bottom
6
January 13, 2020
I added a base plate from sheet styrene
7
January 13, 2020
The whip aerial at the back looked a bit thick so I cut away part of it and added steel wire (I also later added a bit of brass tube over the bottom part of the wire)
8
January 13, 2020
All the parts painted and ready for assembly. I've made some axles and added them through holes drilled in the body
9
January 13, 2020
10
January 13, 2020
11
January 13, 2020
12
January 13, 2020
13
January 13, 2020
14
January 13, 2020
Group shot with R2-D2 and R4-D5 to show scale