Eduard P-47D Dottie Mae
Comments
24 October 2018, 21:04
Nathan Camarillothanks guys! I didn't bother with the flash on the engine heads, as it's only viewable from the front behind the prop. Unfortunately there was lots of flash. If I were building one with a displayable engine I probably. I just trimmed the excess back and figured you wont see the detail has been lost out from the front.
25 October 2018, 09:13
Holger KranichVery nice pit and engine! Will you apply some pigments on the pit floor and some silver drybrushing?
25 October 2018, 09:31
Nathan Camarilloyes, definitely! I did some buff then silver drybrushing in the final image, although it doesnt really come through on the phone camera. Pigments are next before I close it up in the fuselage!
25 October 2018, 09:48
David JanuskaWow. It looks perfect in 1:32 scale. Looking forward for next pictures.
25 October 2018, 16:02
Nathan CamarilloYeah pilots used it to separate the instrument panel into what they needed to pay attention to
26 October 2018, 00:32
TreehuggerI would really like to see this finished, as the engine will be seen from the front on the outside. 🙂
26 October 2018, 14:47
Nathan CamarilloCruising along with the build. I had good luck with the PE this time. I'd use a little dab of white glue to hold the PE in place and then use a glue looper to zap it with thin CA. Usually my PE is a lot messier. I hope I didn't jinx myself!
30 October 2018, 20:39
Nathan CamarilloBeen going a little slow, I got two puppies in October and they're taking all my time!
16 January 2019, 01:11
