Pit Roads 1/35 IJN AA triple
The box art says it all really.
With due care, all parts fit pretty well, along with the customary seam lines.
It is, no doubt, beautifully detailed.
The barrels need the fine seam lines removed. Be careful to not create an hexagonal shape from over correcting the seam lines.
The most notable seam lines here are the ones on the base of each magazine.
Sorry about that. !
THE most challenging part of this kit is the final assembly of all the sub assemblies............................PATIENCE. !
This assembly sequence is the most demanding of all the build. Take note of where the items the drive shaft fit onto are in the right position.
Five pieced go to make this drive motor.
10 pieces here too.
Elevators seat position on the starboard side.
Finished. and now, from all angles.
Don't mind the seam lines on the coffee grinder handles. As these were drop forged units and the line was on the originals too.
Comments
1 13 November 2019, 21:58
Kerry COX
The box art is not too bad, and the model is much like whats on the box top.
The box art is not too bad, and the model is much like whats on the box top.
13 November 2019, 22:03
Kerry COX
Lode, Thanks good buddy.
This is an other 'quickie' I like to do without all the bling and tinsel.
A really simple but time consuming kit, but worth while if your looking for a distraction from the usual run of the mill kits. 👍
I am pleased you had a look mate. 👍
Cheers. 😉
Lode, Thanks good buddy.
This is an other 'quickie' I like to do without all the bling and tinsel.
A really simple but time consuming kit, but worth while if your looking for a distraction from the usual run of the mill kits. 👍
I am pleased you had a look mate. 👍
Cheers. 😉
14 November 2019, 00:43
Kerry COX
There is more fiddling in a bike than this kit mate.
The paint is coming, just like the LAV. 😉
There is more fiddling in a bike than this kit mate.
The paint is coming, just like the LAV. 😉
14 November 2019, 05:17
Bart Goesaert
Seems you are building my complete wanted list... Looking good, but care will be needed when to paint what part or subassembly...
Seems you are building my complete wanted list... Looking good, but care will be needed when to paint what part or subassembly...
4 December 2019, 09:02
Slavo Hazucha
Ha, just discovered this! I like this AA setup a lot... really going against the mainstream, 3 muzzles, odd caliber, for actually aiming it you probably have to use the force... 🙂 Looking really good there 👍 Size comparison with the phalanx perhaps?
Ha, just discovered this! I like this AA setup a lot... really going against the mainstream, 3 muzzles, odd caliber, for actually aiming it you probably have to use the force... 🙂 Looking really good there 👍 Size comparison with the phalanx perhaps?
7 December 2019, 00:18
Kerry COX
Slavo, the size comparison to the Phalanx is on an equal footing.
The detail on both is quite a good reason for having one...........or two. 🙂 hehehehehe 👍
Slavo, the size comparison to the Phalanx is on an equal footing.
The detail on both is quite a good reason for having one...........or two. 🙂 hehehehehe 👍
7 December 2019, 01:36
Album info
A quick build of a new kit on the block from Pit Road