Mirage 2000 C - Serial 4945.
Comments
12 15 December 2015, 14:52
Bart GoesaertInterested. Hope this one will be as much a beauty as your BAF mirage V...
17 December 2015, 12:20
Pierre-Christian BaudruThanks Bart !
I hope this one will be better than the 5BA, at least I learned a lot with the 5BA build and will pay more attention on this next one. Cheers.
17 December 2015, 13:09
Bart Goesaertlooks nice so far. What do you use to fill the panellines before scribing?
20 April 2016, 07:20
Pierre-Christian BaudruThanks Bart ! For the scribing first I draw, based on a 3-view plan, the main lines on the model parts. Then using templates like verlinden or home made ones, I create the lines with a needle. To check the job you can aply a dark wash to see the line you did. Remember that before everything else, as the Heller kit has old panel lines, I had to sand all of them. Cheers.
20 April 2016, 10:05
Bart GoesaertI asked because I intended to do the same but on an Italeri with recessed panellines, but these are large and wrong...
20 April 2016, 10:07
B. M.Looking very good Pierre,
@ Bart: I usually use cyano mixed with baby powder 🙂 So far the only and best option I've come accross. No shrinking at all and you can be sure that nothing will break away while rescribing...
20 April 2016, 12:15
Pierre-Christian BaudruBenoit has just said everything.......CYANO glue + baby powder I agree ! In my case, except for the mobile parts panel lines, the Heller kit has not engraved panel lines so I just had to sand all of them, that's easier then when you have too deep engraved panel lines like on matchbox ou HPM models. Cheers.
21 April 2016, 05:41
GlennI often use cyano glue as gap filler with talcum power it works fast and as you say you can sand it fast! 🙂
28 May 2016, 10:27
