Mitsubishi A6M2b Zero

Original kit part has holes molded in for the seat.  

With a 0.5mm drill bit and vice I drilled out the holes to add a bit of detail. 

Rear bulkhead had 2 big ejector mark holes n either side. Not great from Airfix, could have been on the back of this instead! 

Filled with Perfect Plastic Putty. 

Again with the floor, 2 ejector marks (left and right) and 2 injection marks (top and bottom). 

Filled the hole with he same putty and tried to scratch down and sand the raised injection marks.
 

 

Then glued to top the top of, what will be, the body.