Revell's A400M military transport in 1:144 scale
Hozzászólások
TreehuggerThanks 🙂 I want to point out that I never relied on masking the side windows the way one would expect. What I did was to add primer and paint just around the small window openings on the two hull parts on the sides, then gluing on the small windows, then adding a rough mask, then gluing the parts together. I nearly worked but I wasn't careful enough and had some issues with overspray with grey on grey leaving a subtle edge of sorts, but in theory, it would have worked imo. Ideally I should have avoided letting any paint get near the side window areas so as to avoid spraying on top of the rough masking tape covering the windows. The gloss coats just went over the side windows. I did not dare covering the big canopy piece with gloss coat. Any speck of dust or particles and it would look bad imo. On the flip side, adding a gloss coat over masking tape, seems to have the stuff build up against the masking tape edges, which sucks. I should try being more careful not spraying any more paint around masking than strictly needed.
Nathan DempseyEven with your build issues, the finish came out well. I have this kit, but I want to build it in different markings than provided in the box. I suppose I'll get around to it some day.
Album info
A flawed kit, but should look nice from a little distance. 🙂 In particular, I had issues with:
1) Sink marks in unexpected places. Like on the many small windows.
2) Potential bad engine fit on one engine (or, I did something wrong by sanding off too much plastic)
4) Apparent molding errors on three of four engines.
5) Tricky landing gear assembly.
6) Minor errors on the decal sheet.
7) Weird molding design of stabilizers/elevators, as the plate at the end, is molded into the main hull but not the stabilizers.
8) Refueling probe looks overly simplistic.
9) I suspect the dark grey decals are not dark enough. Unsure.
10) The decals for the yellow prop stripes are badly designed, as you are required to bend the small decal across two sides of the prop. Might as well mask and airbrush on the yellow stripes. I couldn't be bothered with any of that. 🙂
Edit: Shit.. I think I forgot to glue on the props in the proper order, they apparently spin in the opposite direction on each side. :|
Imo, this kit really seems
